modway EEI-272 User manual

EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 1 of 4
Thank you for purchasing the MODWAY OFFICE CHAIR.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M8x45mm x4
Crash Pad x4
1. Base x1 2. Cylinder Column x1 3. Castor x5
A.
B.
Allen Wrench x1
D.
4. Back with Control Mechanism x1 5. Arm x2
Cap Cover x4
C.
EEI-272/ EEI-3417
EEI-273/EEI-3418

EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 2 of 4
STEP 1:
1. Please put Base (1) on a carpeted or padded surface.
2. Insert 5 pieces of Castors (3) into the Base (1) as shown by hand.
3. Repeat the same steps for the remaining 4 pieces of Castors (3).
STEP 2:
1. Carefully turn over the assembled Base (1) from step 1.
2. Insert the Cylinder Column (2) as shown.

EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 3 of 4
STEP 3:
1. Attach 1 piece of Arm (5) to the Back with Control Mechanism (4) by using 2 pieces of Bolts (A) with
2 pieces of Crash Pads (B) as shown, Tighten Bolts (A) by using Allen Wrench (D) and attach 2 pieces
of Cap Covers (C) to the holes on Arm (5) by hand as shown.
2. Repeat the same steps for another Arm (5).
STEP 4:
Insert Back with Control Mechanism (4) into the Cylinder Column (2) as shown

EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 4 of 4
STEP 5:
Assembly is complete. Your office chair is ready to be used now!
Attention: When you use the handle to adjust
the height to be lower, please move away your
legs from the foot ring at the same time.