modway EEI-2715 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI-2715/2716/2717 DINING TABLE
Hardware:
Component:
1 Table Top x1
Thank you for purchasing the MODWAY DINING TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
1
2 Leg x4
2
A Bolt M8x60mm x 8
D Open Wrench M5 x 1
2
2
B
Flat Washer M8 x 8
C
Spring Washer M8 x 8

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI-2715/2716/2717 DINING TABLE
STEP 1:
Please put the Table Top (1) upside down on a carpeted or padded area.
Position 1 piece of Leg(3) into the corner of Table Top (1) as shown.
Insert 2 pieces of Bolt (A) with 2 pieces of Spring Washer (B) and 2 pieces of Flat Washer (C) into the pre-drilled holes on
bottom of Leg (2) through the pre-drilled holes on Table Top (1).
Repeat the same steps for the remaining Legs (2).
Use Open Wrench (D) to tighten Bolts (A) clockwise until secure.
STEP 2:
2
Hardware & Tool required
Ax8 Dx1 Bx8 Cx8
A
A
D
A
2
Carefully turn over the assembled table.
Assembly is completed. Your table is ready to be used now!
B
2
1
2
B
C
B
A
B
C
C
C