modway EEI-2921 User manual

EEI–2921 Dining Table
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 1of 5
Thank you for purchasing the MODWAY DINING TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.
Hardware:
A. Bolt M9.5x700mm x 4
B. Flat Washer M9.5 x 4
C. Nut M9.5 x4
D. Wrench M9.5 x1
E. Tube Plug x4
Component:
1 Glass x1 2 Top Panel x1 3 Leg x4

EEI–2921 Dining Table
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 2of 5
STEP 1:
Put Top Panel (2) on a carpeted or padded surface.
Insert 4 pieces of Bolts (A) into the pre-drilled holes on back of Top Panel (2).
Tighten Bolts (A) clockwise until secure by hand.
Hardware & Tools required
STEP 2:
Insert 4 pieces of Leg (3) on Bolts (A) through the pre-drilled holes on Leg (3).

EEI–2921 Dining Table
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 3of 5
STEP 3:
Insert 4 pieces of Nuts (C) with 4 pieces of Flat Washers (B) into the pre-drilled holes on Leg (3) to the end of
assembled Bolts (A).
Use Wrench (D) to tighten Nuts (C) clockwise until secure.
Hardware & Tools required
STEP 4:
Insert 4 pieces of Tube Plug (E) into the end of pre-drilled holes on Leg (3) as shown.
Hardware & Tools required

EEI–2921 Dining Table
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 4of 5
STEP 5:
Carefully turn over the assembled dining table.
If the table is not level, please adjust Tube Plug (E) on the end of the legs by hand as shown.
STEP 6:
Then carefully put Glass (1) on Top Panel (2) as shown.

EEI–2921 Dining Table
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 5of 5
STEP 7:
Assembly is complete. Your dining table is ready to be used now!