modway EEI-3836 User manual

EEI-3836 CHAIR
Customer Service 908-368-1025︱www.modwa .com
Page 1 of 2
Thank you for purchasing the MODWAY CHAIR.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2. Owing to the size and weight of the Chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Bolt M6*45mm x4
1. Chair Body x1 2. Base x1
A.
Allen Wrench x1
C. Flat Washer x4
B.
Hardware:
Components:
D.
S ring Washer x4

EEI-3836 CHAIR
Customer Service 908-368-1025︱www.modwa .com
Page 2 of 2
STEP 1:
1. Take out the Chair Bod (1), Base (2) and hardware package from the carton.
2. Please put Chair Bod (1) upside down on a carpeted or padded surface.
3. Adjust and match 4 holes of the bottom of Chair Bod (1) and Base (2) ,then insert 1 piece of Bolt (A) with 1
piece of Spring Washer (B) & 1 piece of Flat Washer (C) into one of the matched holes in the bottom of Chair
Bod (1) and Base (2) but don’t fully tighten at this step. Repeat the same steps for other 3 holes.
4. Tighten all Bolts (A) by using Allen Wrench (D) fully.
STEP 2:
Carefully turn over the assembled Chair.
Assembly is com lete. Your Chair is ready to enjoy now!