modway EEI-3801 User manual

EEI-3801 CHAIR
Thank you for purchasing the MODWAY Chair.
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the Chair, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all the pieces out of reach of children.
A.
B.
D.
Bolt M6X25mm x4
Flat Washer x4
Allen Wrench x1
1 Chair Body x1
1
2
2 Steel Frame x1
Customer Service 609-256-9000︱www.modway.com Page 1 of 2
Components:
Hardware：
C. Spring Washer x4

EEI-3801 CHAIR
2
1
B
AD
STEP 1:
1.Please attach the Steel Frame (2) on the seat, and then put the Chair Body (1) upside down on a carpeted or
padded surface.
2. Attach 1 piece of Steel Frame (2) to the bottom of the Chair Body (1) by using 4 pieces of Bolts (A) with 4
pieces of Flat Washers (B) and as shown.
3. Use Allen Wrench (D) to tighten the Bolts (A) clockwise as shown.
STEP 2:
Carefully turn over the assembled Chair.
Assembly is complete. Your Chair is ready to enjoy now!
Customer Service 609-256-9000︱www.modway.com Page 2 of 2
A×4 B×4 C×4
4 pieces of Spring Washers (C)
D×1
C