modway EEI-809 User manual

EEI-809 Chair
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 1of 2
Thank you for purchasing the MODWAY Chair.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6. Please keep all fitting out of reach of children.
Hardware:
A. Bolt M6x30mm x 4
B. Bolt M6x20mm x 2
C. Screw 40mm x 2
D. M5 Allen Wrench x1
E. M4 Allen Wrench x1
F Phillips screwdriver x1
(Not Included)
Component:
1 Seat x1 2 Back x 1 3 Base x 1
1
2
3

EEI-809 Chair
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 2of 2
STEP 1:
Attach Back (2) to the Base (3) by using 2 pieces of Bolt (B).
Tighten Bolts (B) by using Allen Wrench (E) as shown.
Insert 2 pieces Screw (C) into the top holes on the Base (3) of the assembled chair.
Tighten by rotating Screw (C) clockwise with Phillips screwdriver (F) (Not Included).
.
Hardware & Tools required Hardware & Tools required
STEP 2:
Put Seat (1) on a carpeted or padded surface.
Attach Base (3) of assembled chair to the bottom of Seat (1) by using 4 pieces of Bolt (A) as shown.
Tighten Bolts (A) by using Allen Wrench (D) as shown.
Turn over the assemblec chair carefully. Assembly is complete. Your Chair is ready to be used now!
Hardware & Tools required
B
x 2 x 1
E
B
E
3
2
2
3
F
C
3
2
C
x 2
A
x 4
x 1
D
D
1
3
FRONT
A