modway EEI–2308 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI–2308 CHAIR
Hardware:
Component:
ABolt M6x70mm x 8
B
1
Chair Body x1 2 Front Leg x2
Thank you for purchasing the MODWAY CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
1
D
2
Spring Washer M6 x 8
Allen Wrench x 1
CFlat Washer M6 x 8
34
2
Left Back Leg x1 4 Right Back Leg x1
3

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI–2308 CHAIR
STEP 1:
STEP 2:
Hardware & Tool required
Ax8 Bx8 Cx8 Dx1
1
4
C
3
B
B
D
Please put the Chair Body (1) upside down on a carpeted or padded area by two adults.
Open the Zipper on the bottom of Chair Body (1) as shown, to make the corners fully visible.
Take out 4 pieces of Legs (2&3&4) and Hardware Package from the inside of Chair Body(1).
1 4pcs Chair Leg
Zipper on the bottom of chair body
+
Hardware Package
Position one of Front Legs (2) at the corresponding corner as shown.
Insert 2 pieces of Bolt (A)with 2 pieces of Spring Washer (B), Flat Washer (C) into the pre-drilled holes on the bottom
Chair Leg (2) through the pre-drill holes on the bottom of Chair Body (1) as shown.
Repeat the same steps for the remaining Front Leg (2)& Back Legs (3&4).
Use Allen Wrench (D) to tighten all the Bolts (A) clockwise until secure.
Close the zipper on bottom of Chair Body (1).
A
B
C
B
A
A
C
A
C
2 2

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI–2308 CHAIR
Assembly is completed. Your chair is ready to be enjoyed now!
Carefully turn over the assembled chair.
STEP 3: