modway Perdure EEI-811 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI –811 DINING CHAIR
Hardware:
Component:
A Bolt M8x50mm x 1
E Flat Washer M8 x 9
1
Chair Back x1
Thank you for purchasing the MODWAY DINING CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
2 Seat Frame x1 3 Front Leg x2
B
D Spring Washer M8 x 9
F Allen Wrench x 1
2
3
1
3
Bolt M8x57mm x 4
C Bolt M8x90mm x 4

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI –811 DINING CHAIR
STEP 1:
STEP 2:
2
Ax1 Dx1 Ex1 Hardware & Tool required
A
E
D
Cx4 Ex4 Dx4 Hardware & Tool required
1
2
E
D
C
1
Attach Seat Frame (2) to Chair Back(1) by 4 pieces of Bolt (C), 4 pieces of Spring Washer (D) and 4 pieces of
Flat Washer (E) as shown.
Do not fully tighten Bolts (C) at this step also.
Please put Chair Back (1) upside down on a carpeted or padded area.
Then open the black fabric which is attached by the Velcro from back to front on bottom of the Seat Frame (2), The inside of
the Seat Frame(2) will now be visible.
Attach Seat Frame (2) to Chair Back(1) by using 1 piece of Bolt (A), 1 piece of Spring Washer (D) and 1 piece of Flat
Washer (E) as shown.
Do not fully tighten Bolt (A) at this step.

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI –811 DINING CHAIR
Bx4 Ex4 Dx4
STEP 3:
Hardware & Tool required
3
B
3
D
E
2
1
Assembly is completed. The chair is ready to use now!
Fx1 Hardware & Tool required
STEP 4:
F
2
Insert 1 piece of Front Leg (3) into the upper hole on the bottom of Chair Back (1) as shown.
Attach by 2 pieces of Bolt (B), 2 pieces of Spring Washer (D) and 2 piece of Flat Washer (E) as shown.
Repeat the same steps for Front Leg (3).
Do not fully tighten Bolts (B) for either leg.
Carefully turn over the chair.
Please put a heavy object or seat one adult on top of the Seat Frame (2) to pressure the chair for leveling.
Fully tighten the Bolts (A&B&C) with Allen Wrench (F).