modway EEI-3488 User manual

EEI-3488 CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 1 of 2
Thank you for purchasing the MODWAY Chair.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the Chair, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M6x60mm x8
Flat Washer x8
1. Chair Body x1 2. Leg x4
A.
C.
Allen Wrench x1
D.
Spring Washer x8
B.
1
2
2

EEI-3488 CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 2 of 2
STEP 1:
1. Please put Chair Body (1) upside down on a carpeted or padded surface.
2. Open the zipper on the bottom of the Chair Body (1) and take out the 4 pieces of Legs (2) and hardware
package.
2. Attach 4 pieces of Legs (2) to the corner of Chair Body (1) by using 8 pieces of Bolts (A) with
8 pieces of Spring Washers (B) and 8 pieces of Flat Washers (C) as shown.
4. Use Allen Wrench (D) to tighten all Bolts (A) clockwise as shown.
Legs+ Hardware package inside
STEP 2:
Close the zipper on the bottom of Chair Body (1). Carefully turn over the assembled chair.
Put the seat cushion on the seat and fix by the Velcro.
Assembly is complete. Your Chair is ready to enjoy now!