modway Loryn MOD-5357 User manual

MOD-5357 and MOD-5358 TWIN BED FRAME
are
Short Board x2
Leg I x2
Long Board x2
Leg II x2
Center Rail x1
Roll Slats x13
Support Leg x2
Components:
WWW.MODWAY.COM

Put 1 piece of Short Board (1) upside down on a carpeted or padded area by two adults.
Insert 1 piece of
the numbers shown on Legs and Short Board must match.
Leg II (6) and 1 piece of Leg I (5) into the Short Board (1) as shown. Please note
Secure them by using 4 pieces of Bolt (B), 4 pieces Spring Washer (C) and 4 pieces of Flat Washer (D).
Use Allen Wrench (F) to tighten the Bolts (B) clockwise until secure.
Repeat the same steps for the remaining 1 piece of Short Board (1), 1 piece of Leg I (5) and 1 piece
of Leg II (6).
Place 1 piece of Long Board (2) to the assembled 2 pieces Short Board (1) by two adults.
Attach them by using 4 pieces of Bolt (A) as shown.
Use Allen Wrench (G) to tighten the Bolts (A) clockwise until secure.
Repeat the same steps for the remaining 1 piece of Long Board (1).
WWW.MODWAY.COM
F
B
C
D
B x 8 C x 8 D x 8 F x 1
G
A x 8 G x 1

Insert Center Rail (3) to the bracket (provided) on Short Board (1) and then secure with 1 piece
Screw (E) per each end. Tighten the Screw (E) with Phillips Head Screw Driver (not provided).
WWW.MODWAY.COM
Secure 2 pieces of
Support leg (4) clockwise until secure.
Support Leg (4) to the Center Rail (3) with pre-set T-nut as shown. Tighten the
E
E x 2

Hardware may loosen over time. Periodically check that all connections are tight.
Assembly is complete.The bed frame is ready to use now!
WWW.MODWAY.COM
E
E
E
E x 8
E
E
E
E x 4

CONNECTING BED FRAME TO HEADBOARD
Reminder: All the hardware packed in the
Headboard you bough. Please use only the above
hardware from Headboard Hardware Package to
assemble the Bed Frame and Headboard.
WWW.MODWAY.COM

CONNECTING BED FRAME TO HEADBOARD
WWW.MODWAY.COM