modway EEI-3093 User manual

EEI-3093 SOFA BED
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 1 of 4
Thank you for purchasing the MODWAY SOFA BED.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the sofa bed, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all fitting out of reach of children.
Hardware:
A. Bolt M6x35mm x 8
B. Flat Washer M6 x 8
C. Allen Wrench x1
Component:
1 Sofa Cushion x1 2 Front Leg x 2 3 Back Leg x 2
2
1
2
3

EEI-3093 SOFA BED
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 2 of 4
STEP 1:
Please put Sofa Cushion (1) on a carpeted or padded surface.
Open the zipper in the bottom of the Sofa Cushion (1) and take out 2 pieces of Front Leg (2) and 2 pieces of
Back Leg (3) from the Legs package.
Attach 1 piece of Front Leg (2) to the bottom of Sofa Cushion (1) by using 2 pieces of Bolts (A) with 2 pieces of
Flat Washers (B) as shown. Repeat the same steps for the other 1 piece of Front Leg (2).
Tighten Bolts (A) by using Allen Wrench (C) as shown.
Hardware & Tools required
STEP 2:
Attach 1 piece of Back Leg (3) to the bottom of assembled Sofa Cushion (1) and Front Leg (2) by using 2
pieces of Bolts (A) with 2 pieces of Flat Washers (B) as shown. Repeat the same steps for the other 1 piece of
Back Leg (3).
Tighten Bolts (A) by using Allen Wrench (C) as shown.
Hardware & Tools required
A
x 4
x 4
B
x 1
C
A
C
B
2
2
1
Legs Inside
A
C
B
1
A
C
B
3
3
A
C
B
A
x 4
x 4
B
x 1
C

EEI-3093 SOFA BED
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 3 of 4
STEP 3:
Carefully turn over the assembled Sofa Cushion (1), Front Leg (2) and Back Leg (3) from step 2 as shown.
STEP 4:
Lift the back of assembled Sofa Cushion (1) as shown.

EEI-3093 SOFA BED
Customer Service 908-368-1025︱www.modwayfurniture.com
Page 4 of 4
STEP 5:
Assembly is complete. Your Sofa Bed is ready to be used now!