modway MOD-5467 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
MOD-5467 TWIN BED FRAME
Hardware:
Component:
A Bolt M8x25mm x16
B Allen Wrench x1
1 Long Board x2
Thank you for purchasing the MODWAY TWIN BED FRAME！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bed frame, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
C Side Plastic Cover x24
1
1
2
2
3
3
3
3
4
3
2 Short Board x2
3 Leg x4 4 Slat x12

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
MOD-5467 TWIN BED FRAME
Ax16 Bx1
STEP 1:
Place Long Boards (1), Short Boards (2) and Legs (3) upside down on a carpeted or padded area.
Insert the end of 1 piece of Long Board (1) and Short Board (2) into 1 piece of Leg (3) as shown.
Repeat the same steps for remaining of Legs (3).
STEP 2:
Insert 4 pieces of Bolt (A) into the pre-dilled holes on Leg (3) through the pre-drilled holes on the end of Long Board (1) and
Short Board (2) as shown.
Repeat the same step for remaining 3 pieces of Legs (3).
Tighten all Bolts (A) by using Allen Wrench (B) clockwise until secure.
Hardware & Tool required
2
2
1
1
3
3
3
3
2
1 3
A A
A
B
A
1
1
2
2
3
3
3
3

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
MOD-5467 TWIN BED FRAME
Cx24
STEP 3:
Hardware & Tool required
1
4
4
C
2
1
2
Carefully turn over the assembled Long Boards (1), Short Boards (2) and Legs (3).
Insert 2 piece of Side Plastic Cover (C) into each end of Slat (4) as shown.
Insert the assembled Side Plastic Covers (C) into the corresponding holes on Long Board (1) as shown.
Repeat the same steps for remaining 11 pieces Slats (4).
Assembly is complete. Your bed frame is ready to be enjoyed now!
C