molex 69020-0680 User manual

A.S.04.03.18/ISSUE E
FILENAME: SD-69020-0680
ARBOR PRESS FIXTURE
PART No. 69020-0680
FOR MOLEX PRODUCT 5320 and 90365
DESCRIPTION
This fixture will terminate Molex Product 5320 and 90635 on
to pre-cut robbon cable.
FEATURES
1. This fixture can only be used in a standard Arbor Press
part No. 69020-0660.
2. For loose piece connectors only.
3. Hand loading of assembled connectors and cable.
SPECIFICATION
SIZE: 210mm x 160mm x 120mm
WEIGHT: 3Kg
WORKING SERVICES: None

A.S.04.03.18/ISSUE E
FILENAME: SD-69020-0680
SET-UP
1) Fix upper block onto Arbor Press spindle and tighten
locking screw.
2) Place lower termination fixture onto mounting platform of
Arbor Press.
3) Make a few samples following the next section (operation)
and then check termination heights. If adjustment is
required see adjustments section.
OPERATION
1) Insert connector into fixture slot (cap downwards).
2) Slide cable into connector until it touches backstop.
3) Pull handle of Arbor Press down fully to terminate
connector.
4) Raise handle and remove harness.
5) Repeat from 1.

A.S.04.03.18/ISSUE E
FILENAME: SD-69020-0680
ADJUSTMENTS
1) If termination height is incorrect then follow the
procedure below.
2) Loosen the stud nuts in the centre of the Arbor Press.
3) Loosen clamp bolt to column at the rear of the Arbor
Press.
4) Adjust upper part of Arbor Press up or down using the nuts
on the central stud.
5) Re-tighten nuts and clamp bolt.
6) Recheck termination height.
MAINTENANCE
1. Keep fixture clean at all times.
2. Clean fixture with brush.
3. Oil moving parts weekly, when in use.
4. Store in a clean dry environment.
SPARE PARTS
Number Description
1) 69020-0682 Guide rail assembly 5320
2) 69020-0688 Base plate
3) 69020-0684 Guide rail assembly 90635
4) 69020-0686 Cable stop block
QUALITY
Check termination quality against the Molex wire termination
specification for relevant product being terminated e.g.: PS-
5230.
A quality procedure should be in place to monitor output from
this fixture.
LIMITATIONS
This Arbor Press can only be used for product stated in the
description section of this leaflet.