MONARCH INSTRUMENT Nova-Strobe Use and care manual

Nova-Strobe Battery Replacement Instructions
For all Nova-Strobe models
[A]
[B]
[C]
[D1]
[D2]
Dismantling the unit is the easy part. . .
1. Remove the lens [A] by separating the two tabs
that hold it in place.
1a) For LED models, there are two (2)
internal wires connecting the white
connector that will need to be carefully
removed.
2. Slide the reector [B] and lamp out as detailed
in the Lamp Replacement section of the User
Manual.
3. The four (4) screws [C] must be removed so the
reector housing can be detached from the main
body.
4. Remove the four (4) additional screws [D1] & [D2]
in the case halves opposite the input and output
jacks.
5. The case halves can now be separated, exposing
the batteries; the batteries should be sent to a
recycling center or returned to Monarch for
proper disposal.
15 Columbia Drive, Amherst NH 03031-2334 Tel.: [phone] • Fax: [phone]
www.monarchinstrument.com [email protected]
Before you open the housing, know that during the reassembly there are multiple points
that need to align correctly to close the housing securely.
Some of them include:
A — Display board sits in groove
A — DC Connector spans both case halves
B — Mounting T-nut sits in slot as shown
B — Lanyard knot surrounds screw standoff and protrudes through the notch in the case
C — Trigger sits in case brackets with wires tucked out of the way
D — PCB aligns in a retaining groove
D — Battery holders (2) nests in brackets, there is a right and wrong way to insert them
Image A Image B Image DImage C

Replacing the Battery
1. Be sure that the replacement battery is
plugged into the PCB rmly.
2. Carefully place the right half (1055-4241-
111) onto the left (1055-4242-111).
3. Align the display board [E], battery [F],
and main PCB [G] into the slots provide in
the case.
4. Align the display and battery rst, then
from the front of the unit, guide the PC
Board into the retaining slots with a
wooden stick. Ensure the trigger wires [H]
and DC Jack [I] are properly in place.
[F]
[E]
[G]
[H]
[I]
[J]
[K]
Nova-Strobe Battery Replacement 1/2022 v3.1
[D1]
[D2]
[D1]
Top half of the
Battery Holder
sits in the right
side case.
Note the position
of the cradle
guides
Helpful Tip:
Placing the left side of the case
on a roll of tape or other lift
will prevent the speed knob
from pushing the PCB out of
the retaining slots when
aligning all.
www.monarchinstrument.com
5. Fasten both halves using two 2"self tapping screws [D]
(1053-3328-001) through the body of the right half. Do
not over tighten screws.
6. Gently pry apart case halves at the base of the handle
and insert T-nut [J] (1053-0270-001) into slot in left
handle.
7. Slip knotted end of wrist strap [K] (3051-2000-015) over
left half handle standoff and through slot provided.
8. Carefully press case handles together, ensuring the
wrist strap ts into the notch provided and no wires are
pinched between the case halves.
9. Reattach the reector housing.
10.Do not over tighten screws [C], [D1], [D2].
[email protected]