Monarch 9462 User manual

OPERATING
INSTRUCTIONS
The Monarch® 9462™ Single-Station Battery Charger
charges one 7.4V lithium-ion battery at a time for the
following printers:
Sierra Sport2™ 9460™
Sierra Sport3™ 9433™
Monarch® Pathfinder® Ultra® Silver 6032™
Monarch® Pathfinder® Ultra® Platinum 6039™
Pathfinder® 6057
Pathfinder® 6140
Note: You must charge a battery before using it.
Information in this document supercedes information
in previous versions. Check our Web site
(http://www.monarch.com/) for the latest
documentation and release information.
TC9462OI Rev. AM 9/12 ©2009 Avery Dennison Corp. All rights reserved.

WARNINGS
Use only a Monarch-qualified battery. The battery
could be damaged or explode if placed on a
different charger.
Do not charge non-rechargeable batteries in this
charger.
Do not throw the battery in the trash. Dispose
according to your local regulations.
Do not disassemble, short-circuit, heat above
80°C, or incinerate the battery. It may explode.
Follow the operating and storage limit
specifications listed at the end of these
instructions. Otherwise, the battery may
permanently lose its charge capacity.
Setting Up the Equipment
To set up the equipment:
1. Plug one end of the power supply into a wall
electrical outlet.
2. Plug the other end of the power supply into the
back of the charger.
The Power LED is on when the charger is set up and
plugged in.
2

Charging the Battery
To charge the battery, insert the battery into the
charger, with the ribbed end sticking out. Charging
time can take up to three hours. It takes
approximately 1 hour to reach the 80% level (where it
is now usable). To reach 100%, it takes
approximately 2 hours more.
Reading the Display
Power LED – on (solid). Charger is plugged in.
Charging
LED – fl
battery; on (solid)
charging is compl
ashes when you insert the
during charging; off when
ete.
Complete LED – flashes when the battery is 80%
charged; on (solid) when the battery is 100%
charged.
3

4
Complete g
ter
harge, call Service.
s, remove the battery, wait for the
LEDs t ry.
Specifi s
Troubleshooting
When an error occurs, the Charging and
LEDs blink together. In this case, repeat the chargin
process. If the error still occurs, repeat the process
with a new battery. If there is a still a problem af
the second repeat c
In between charge
o stop flashing, then re-insert the batte
cation
Operating Limits:
Te
Storage Lim
mperature 32°F to 104°F (0°C to 40°C)
5% to 90% non-condensing
Humidity
its:
mperature F (-40°C to 70°C)
Humidity ndensing
r
3” (76.2 mm)
Shipping Weight:
upply
Input: Universal switching power supply, 90
ice, supplies,
s for our locations
Toll Free:
1-800-543-6650 (In the U.S.A.)
1-800-387-4740 (In Canada)
Te -40°F to 158°
5% to 90% non-co
Charge
Length:
Width: 3” (76.2 mm)
3.25” (82.55 mm)
Height:
Input: 12 to 16 VDC/14W
1.16 lbs. (.53 kg)
Power S
to 264 VAC, 50/60 Hz.
Output: 12 VDC/15W max
Visit our Web site for sales, serv
information, and telephone number
throughout the world.