
CONNECTION DIAGRAM
The following illustration shows a typical connection using this HDMI splitter, a Blu-ray drive source,
and two displays.
(3D) Blu-ray player
Power Adapter
HDTV 2
(3D, 4K×2K)
HDTV 1
(3D, 4K×2K)
CONNECTION AND OPERATION
1. Using a High Speed HDMI cable (not included), plug one end into the output of your blu-ray player
(or other video source device). Plug the other end into the INPUT port on the back of the splitter.
2. Using a High Speed HDMI cable (not included), plug one end into the input on your first display. Plug
the other end into the OUTPUT 1 port on the back of the splitter.
3. Using a High Speed HDMI cable (not included), plug one end into the input on your second display.
Plug the other end into the OUTPUT 2 port on the back of the splitter.
4. Plug the DC connector on the power adapter into the DC 5V input port on the back of the splitter.
Plug the power adapter into a nearby power outlet.
5. Power on your source device and the two displays. Content played on the source device should be
seen on both displays.
Note: The splitter's EDID display detection function operates on the display connected to OUTPUT 1. If
you have two displays with different capabilities, such as one that has a maximum resolution of 720p
and another capable of 1080p, you should connect the least capable display to OUTPUT 1. This
ensures that the source device chooses video settings that can be shown on both displays.
NOTICE
Specifications, hardware, software, packaging, and manuals are subject to change without
notice.
HDMI, the HDMI Logo, and High-Definition Multimedia Interface are trademarks or registered
trademarks of HDMI Licensing LLC in the United States and other countries.
Dolby is a registered trademark of Dolby Laboratories.
DTS is a registered trademark & the DTS logos and Symbol are trademarks of DTS, Inc.
2