Monoprice 3347 User manual

Need Help? We’re here for you!
Contact us: www.monoprice.com/contactus
Product pictures are for reference only.
Specifications described herein are subject to change without prior notification.
Monoprice™ and all Monoprice logos are trademarks of Monoprice Inc.
Copyright © 2023 Monoprice, Inc. All rights reserved.
CUSTOMER SERVICE
The Monoprice Customer Service department is dedicated to ensuring that your ordering, purchasing, and
delivery experience is second to note. If you have any problems with your order, please give us an
opportunity to make it right. You can contact a Monoprice Customer Service representative through the
Live Chat link on our website www.monoprice.com or via email at [e-mail]. Check the
website for support times and links.
TECHNICAL SUPPORT
Monoprice™ is pleased to provide free, live, online technical support to assist you with any questions you
may have about installation, setup, troubleshooting, or product recommendations. If you ever need
assistance with your new product, please come online to talk to one of our friendly and knowledgeable
Tech Support Associates. Technical support is available through the online chat button on our website
www.monoprice.com or through email by sending a message to [email protected]. Check the website
for support times and links.
Monoprice™ and all Monoprice logos are trademarks of Monoprice Inc.
Monoprice™ Professional Modular
Crimps, Strips, and Cuts Tool with Ratchet
Monoprice, Inc.
1 Pointe Drive, Suite 400
Brea, CA 92821 – USA
www.monoprice.com
P/N
3347
User Manual

Instructions
Squeeze handles until it stops to open the handles.
1. Insert cable between stripper blades.
a. Insert 4P or 6P cable from the top end of the stripper blades until it touches the stop guide (stripping
length 6mm).
b.Insert 8P cable between stripper blades and let it extend a little past the lower cutter blade.
2. Squeeze the handles (the cable must be kept perpendicular to the tool) then pull the cable from the tool.
3. Round cable stripping:
Insert round cable between the round cable stripper blades, squeeze handles and rotate cable and
handles.
4. Remove the outer jacket and insert the stripped cable into the plug. Make sure the left wire at one end
matches the right wire at the other end.
5. Place modular plug with cable into the tool's holder. Make sure the stripped wire is between the tab and
gold contacts. Squeeze handles until it stops.
6. Remove the crimped plug from the tool.
7. During the crimping process, you may turn the screw on the ratchet in counterclockwise direction to
stop the incorrect operation. (RATCHET RELEASED)
8. To crimp "DEC" plug, follow step 1 to step 3. Remove the screw on the left side of the 6P holder, insert the
"DEC" plug and cable into the 6P holder and squeeze handles till it stops.