6
User Manual
Moonboon Motor
Mounting
The nylon string is to be fastened as
close to the center of the Baby Ham-
mock, Twin Baby Hammock or Cradle
as possible while still leaving dis-
tance between the motor wire and the
Spring. Make sure to prevent the wire
from touching and wearing out the
fabric covering the spring.
4
5
6
3
Please note
First, you must prepare your chosen mounting method; Tripod Stand 2.0,
Door Frame Clamp or Mounting Kit.
If you hang your Moonboon Motor from a ceiling hook and strap or
chain, you must carefully read the section on WEIGHT.
Attach the carabiners as described on page 5.
Now use the upper carabiner for hanging the Motor. Feed the power
cable into the small hole at the top of the Motor. The power cord is 10
feet / 3 meters long, so you need to place your set-up near a power
outlet.
Make sure that the power cable does not trail down the Motor, Baby
Hammock, Twin Baby Hammock or Cradle, but rather is kept away from
them.
Now hang the spring and then your choice of Baby Hammock, Twin
Baby Hammock or Cradle in the carabiner under the Motor. Check that
the two carabiners open and close properly.
Once the Baby Hammock, Twin Baby Hammock or Cradle is mounted,
the nylon string coming out of the bottom of the Motor is to be wound
around the fabric at the top of the Baby Hammock/Twin Baby Hammock/
Cradle. Do this by pulling the string down, winding it around the fabric,
and fastening the S-hook around the string so that it is fixed in place. See
the illustration below.
It is important that the string is securely fastened before you let go of it.
Once the Moonboon Motor and the nylon string are in place, you may
turn the power on. Read the sections on HEIGHT and WEIGHT before
using the Motor.
1
2
If the Moonboon Motor is suspended
from the ceiling, it is important to use
a stainless steel hook without coating.
Similar precautions must be applied if
you use a metal chain.
Please note
Baby Hammock Twin Baby Hammock Cradle
