Mooreco Podium User manual

Podium
UPDATED AS OF: 01/26/2021 1 of 10
INSTRUCCIONES DE ENSEMBLAJE
NO LA TIRE
INSTRUCTIONS DE MONTAGE
NE PAS JETER
ASSEMBLY INSTRUCTIONS
DO NOT THROW AWAY!

P11 - Handle
P12 - Book Stop
P13 - Timing Rod
P14 - Shelf Clip
P15 - Key
P16 - Lock Assembly
P17 - Door Hinge
P18 - Plastic Cap
A - M4 x 16mm PH Wood
B - M6 x 12mm SH
C - M4 x 10mm PH
D - M4 x 12mm PH
E - M4 x 30mm PH
Parts List
UPDATED AS OF: 01/26/2021 2 of 10
Hardware
x1
x1
x1
x8
x2
x1
x2
x6
x4
x30
x8
x2
x2
P1 - Left Panel
P2 - Right Panel
P3 - Back Panel
P4 - Door
P5 - Podium Top
P6 - Base Panel
P7 - Top Panel
P8 - Shelf
P9 - Locking Caster
P10 - Non-Locking Caster
x1
x1
x1
x1
x1
x1
x1
x2
x2
x2

Review full assembly instructions and
check that all parts are present before
beginning assembly. Heavy or large
furniture may require multiple persons in
order to properly assemble. If you have
questions regarding assembly, contact
the manufacturer before continuing.
Damage due to incorrect assembly may
not be covered by warranty. Do not use
product unless all screws are tight. Check
all screws for tightness at least every
six months. If parts are broken, missing,
damaged, or worn, stop use of the product
until repairs are made by your dealer using
factory authorized parts.
WARNINGS AND DISCLAIMERS
UPDATED AS OF: 01/26/2021 3 of 10
Previo a comenzar el proceso de
ensamblaje favor de revisar las
instruccionesyasegurarsequecuenta con
todas las partes y materiales necesarios.
Es posible que los muebles grandes o
pesados, requieran mas de una persona
para ensamblarlos correctamente. Por
favor contacte al fabricante directamente
si tiene alguna duda o pregunta antes de
continuar con el proceso de armado del
producto. La garantía no cubrirá daños
que ocurrieron por errores cometidos
durante el proceso de ensamblaje. Todos
los tornillos deben estar ajustados previo
el uso del producto. Debe revisar los
tornillos periódicamente, por lo menos
cada seis meses y asegurarse de que
estén bien ajustados. Por favor detenga
el uso del producto si partes del producto
se pierden, rompen, se deterioran por uso
o se rompen. Favor de contactar a su
distribuidor para que le envíen las partes
necesarias o realice las reparaciones
necesarias con partes autorizadas por el
fabricante.
Avant de commencer l’ assamblage
veuillez consulter les instructions
complètes et vérier si vous avez toutes
les pièces nécessaires. Ill est possible que
plusieurs personnes soient nécessaires
pour assemble des meubles grand ou
lourds. En cas de doute sur l assamblage
contactez le fabricant avant de continuer.
Les dommages encourus pendant
l’assamblage ne seront pas couvert par
la garantie. Ne pas utiliser le produit sans
vérier que tous les vis soient serrées.
Vériez que les vis sont serrées au moins
tous le 6 mois. Si aucune pièce se casse,
manque, est endommagée ou usée,
arrêtez d’ utiliser de produit jusqu’à ce
que le vendeur le repaire a l’aide de pièces
autorisées par la fabricant.
ADVERTENCIAS Y RENUNCIAS AVERTISSEMENTS

STEP 1
UPDATED AS OF: 01/26/2021 4 of 10
STEP 2
Install all 4 casters to Base with 16 screws (B). Locate Locking Casters opposite the
side nearest to the grommet.
Secure both Left and Right Panels to Base using 4 screws (B).
P9
P10
B
P1
P2
B

Install Top Panel using four screws (B).
STEP 3
UPDATED AS OF: 01/26/2021 5 of 10
Install Back Panel using 6 screws (B).
STEP 4
P3
B
P7
B

Loosen set screw on Timing Rod so that it can be shortened. Insert into square slots on
both sides of cabinet and once fully extended tighten set screw to lock in place.
STEP 5
UPDATED AS OF: 01/26/2021 6 of 10
STEP 6
Attach both Door Hinges using 4 screws (C).
P13
P17
C

STEP 7
UPDATED AS OF: 01/26/2021 7 of 10
Attach Door to hinges using 4 screws (C).
STEP 8
Attach Handle to Door using 2 screws (D).
P4
C
P11
D

STEP 9
UPDATED AS OF: 01/26/2021 8 of 10
P16
Install Lock Assembly in Door as shown.
STEP 10
Place all 8 Shelf Tabs at desired heights
inside the podium. Each set of four
should be aligned horizontally to ensure
shelves are flat.
P15
P14

S T E P 11
UPDATED AS OF: 01/26/2021 9 of 10
Set Shelves inside podium on top of tabs
with grommets positioned towards the
back of cabinet.
STEP 12
Screw Podium Top to adjustable brackets with 4 wood screws (E).
P8
P5
A

STEP 13
UPDATED AS OF: 01/26/2021 10 of 10
THIS COMPLETES ASSEMBLY INSTRUCTION
Install Book Stop onto Podium Top using 2 screws (E).
STEP 14
E
P12
STEP 14
Insert 6 Plastic Caps into threaded inserts in Back Panel and Left Panel.
P18