
1
2
3
FOR USE WITH THE BEAST CREATOR. SOLD SEPARATELY.
REFILLING THE BIO MIST TROUBLESHOOTING
SCAN FOR A REFILL PACK
TROUBLESHOOTING VIDEO:
SCAN HERE FOR IMPORTANT
SUPERVISOR INFORMATION:
*SOLD SEPARATELY
Flick Power Mode Switch to Power Off position,
remove Chamber from Base.
Unscrew lid of Bio Mist Rell and locate the cross-shaped
hole on the Base.
Place the end of the Bio Mist Rell in the hole
until it stops and rmly squeeze Bio Mist Rell
with a pumping action to empty the bottle.
To follow these Rell Pack steps, enter into "Supercharged Mode",
as detailed in Experiments 1 and 2.
Make sure that the Power Mode Switch is in the up position
(Creation Mode) to activate "Supercharged Mode".
To check you are in "Supercharged Mode", look at the Alarm LED,
this will be glowing red.
NOTE The Beast Creator* instruction steps
differ from this instruction manual.
BIO MIST & EXPERIMENT
REFILL PACK!
BIO MIST & EXPERIMENT
REFILL PACK!
BIO MIST & EXPERIMENT
REFILL PACK!
BIO MIST & EXPERIMENT
REFILL PACK!
INSTRUCTION
MANUAL
Parental consent required before going online and viewing online content.