Morphy Richards 10 CUP FILTER COFFEE MAKER - REV 2 User manual

10 cup filter coffee maker
Please read and keep these instructions
getting the best from your
new coffee maker
•Safety first
Caution must be used when handling hot water, coffee or steam.
•Run water through your machine before first
use
It is important to run water through your coffee maker in order to
rinse the machine. You can also run water through to warm your
coffee machine.
•Descale as appropriate for the hardness of the
water in your area
It is important to descale as the performance of your coffee
maker may be impaired by limescale and other impurities in the
water supply.
47039 rev1 7/2/06 8:45 AM Page 1

Important safety
instructions
The use of any electrical appliance
requires the following common sense safety
rules.
Primarily there is danger of injury or
death and secondly the danger of damage
to the appliance. These are indicated in the
text by the following two conventions:
WARNING: Danger to the person!
IMPORTANT: Damage to the appliance!
In addition we offer the following safety
advice.
Location
•Remove all the packaging and retain for
future reference.
•Ensure the coffee maker is used on a
firm, flat surface.
•Do not use the coffee maker outdoors or
in a bathroom.
•Do not place the coffee maker on a
highly polished wooden surface as
damage may occur to the surface.
•Do not place the coffee maker on or near
hot surfaces such as a hot plate or
radiant rings or near a naked flame.
•WARNING: Do not place the coffee
maker onto a metal tray or metal
surface whilst in use.
Children
•Children do not understand the dangers
associated with operating electrical
appliances. Never allow children to use
this appliance.
Other safety considerations
•Disconnect the coffee maker from the
mains supply when filling, cleaning or
not in use.
•Keep the outside of the coffee maker
area clean and dry at all times.
•Do not touch hot surfaces. Always use
handles or knobs.
•Do not immerse the coffee maker itself in
water and always ensure the electrical
connections are kept dry.
•Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions or has been
damaged in any manner. Ring the
helpline number for advice on
examination and repair.
•The use of attachments or tools not
recommended or sold by Morphy
Richards may cause fire, electric shock
or injury.
•Do not use abrasive cleaners on the
outside of the coffee maker, they may
scratch the surface. Clean only with a
soft damp cloth.
•Do not use the coffee maker for anything
other than its intended purpose.
Product safety
•Never use warm or hot water to fill the
water reservoir.
•Do not overfill the water reservoir.
Treating scalds
•Run cold water over the affected area
immediately. Do not stop to remove
clothing, get medical help quickly.
Personal safety
•Ensure the lid of the glass jug is securely
in place before pouring.
•Take care to pour hot coffee slowly and
carefully without tipping the glass jug too
fast.
•Do not place the glass jug on the hot
plate unless the lid is in position.
•Do not fill above the capacity of the
water level gauge marked on the jug.
•Do not use the glass jug in a microwave.
•Do not touch metal parts until the unit
has cooled.
2
47039 rev1 7/2/06 8:45 AM Page 2

3
The first time you use your coffee maker
Before using your coffee maker for the first
time operate the coffee maker with water only.
Hinged reservoir
lid
Removable
permanent
mesh filter
Removable filter holder
Non drip valve
Jug lid
Glass jug with
water level
indicator
Hot plate
Water level
indicator
Digital LED display
Filter locating tab
Electrical requirements
Check that the voltage on the rating
plate of your appliance corresponds with
your house electricity supply which must be
A.C. (Alternating current).
For appliances with fitted plug.
If the socket outlets in your home are not
suitable for the plug supplied with this
appliance the plug should be removed and
the appropriate one fitted.
WARNING : The plug removed from
the mains lead, if severed, must be
destroyed as a plug with bared flexible
cord is hazardous if engaged into a
live socket outlet.
Should the fuse in the 13 amp plug
require changing a 13 amp BS1362 fuse
must be fitted.
WARNING: This appliance must be
earthed.
Control panel buttons
with indicator lights
Features
Measuring spoon
WEEE
For electrical products sold within
the European Community.
At the end of the electrical products
useful life it should not be disposed of with
household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer
for recycling advice in your country.
47039 rev1 7/2/06 8:45 AM Page 3

General use
1Lift up the hinged reservoir lid.
2Fill the water reservoir with the required
amount of water using the water level
indicator as a guide. Both the jug and
the water level indicator are marked in
cups. Do not exceed the maximum level
on the water gauge.
3Spoon the required amount of ground
filter coffee into the mesh filter spreading
it evenly. We suggest one rounded
dessert spoon for every cup, but
individual tastes will vary. Ensure the
filter is sitting properly in the filter holder
and do not fill above the mesh line.
4Close the reservoir lid.
5Select the strength of coffee required,
using the strength selector on the
resevoir lid.
6Slide the jug into the coffee maker
ensuring it sits correctly on the hot plate.
The jug lid must be in place during the
brewing process, otherwise the non-drip
valve will not open, causing the filter to
flood.
7Plug the filter coffee maker in at the wall
socket and switch the coffee maker
‘ON’. The red power light will glow to
show the coffee maker is working.
8Hot water will start to flow through the
coffee grounds and into the glass jug as
coffee.
9When the coffee has been made, serve
as required. The anti-drip valve will
prevent any remaining coffee dripping
onto the hot plate. Ensure that the jug is
replaced on the hot plate after serving.
While the coffee maker is switched ON
the hot plate will keep the coffee warm.
10Switch off the coffee maker when the jug
is empty or the coffee is no longer
required.
WARNING: The coffee maker and
hot plate are hot and remain hot for
some time after switching off.
11Allow the unit to cool.
12Remove the permanent filter and empty
the used coffee grounds. Wash the filter
immediately and dry thoroughly.
NOTE: The mesh will become discoloured
after a while, due to the staining effect of
coffee.
NOTE: As a safety feature, this unit will
switch off after two hours.
Refilling
1Switch off the coffee maker and allow 3
minutes to cool before refilling with cold
water.
4
47039 rev1 7/2/06 8:45 AM Page 4

Control panel
To set the clock
•Press the ’PROG’ button once, and the
‘CLOCK’ text will appear in the display.
•Press the ‘HOUR’ and/or ‘MIN’ buttons
to set the desired time.
•If no buttons are pressed, the display will
revert to the time display within 10
seconds.
To set ‘wake up’ time
•Press the ‘PROG’ button twice, and the
‘TIMER’ text will appear in the display.
•Press the ‘HOUR’ and/or ‘MIN’ buttons
to set the desired time when the
machine should start to brew the coffee.
•When the required ‘wake-up’ time is set,
to exit, press the ‘PROG’ button once
until the display reverts to the time
display.
•If no buttons are pressed, the display will
revert to the time display within 10
seconds.
NOTE: The machine will not start
automatically brewing the coffee,
unless the automatic ‘wake-up’ is
set on AUTO. (See instructions
below)
To brew using the automatic
‘wake up’ timer function
NOTE: The automatic brewing
function will work only if the time
and the “wake up’ time are set.
Remember to fill the tank with the
amount of water required and
permanent filter with coffee too.
•To activate the automatic ‘wake up’
brewing function press twice or until
the green light AUTO turns on.
In this mode the coffee maker will turn
on at the pre-set time and start to brew
the coffee.
•To cancel the automatic ‘wake up
brewing function press the once or
until the green light AUTO turns off.
Note: When the pre-set brewing time is
reached the machine will automatically
switch to brew mode;to switch off the
machine press the button until both
lights (RED and GREEN) are off.
CLOCK
TIMER
ON
AUTO
PROG
HOUR
MIN
5
Red light Green light
47039 rev1 7/2/06 8:45 AM Page 5

To brew your coffee manually
•Fill the water tank with the amount of
water required and permanent filter with
coffee too.
•Press the button once, the ‘ON’
light will glow red.
•To turn off the machine press the twice
or until the red light and the green
lights are off.
Locating the filter
1To remove the filter, lift both the holder
and mesh filter out to clean. (see
cleaning)
2To refit, place the removable filter holder
into the top of your coffee maker, making
sure the tab lines up with the rib. Then
place the permanent mesh filter inside the
filter holder.
Descaling
•If you live in a hard water area, we
recommend that your coffee maker is
descaled at regular intervals, e.g. every 2-
3 months. In areas of moderately hard
water you should descale every 6 months.
•If the water filters through more slowly
than usual, it is a sign that descaling is
necessary.
•We recommend you use proprietary liquid
descaler which is especially made for
coffee makers and plastic kettles. Follow
the instructions on the bottle or sachet,
and then operate the coffee maker with
just water 3 times before making coffee.
•Do not use kettle descaler unless the
packet specifically states it is suitable for
coffee makers.
Note: The permanent mesh filter should
not be used during descaling.
Cleaning care
Unplug the coffee maker and allow to
cool.
Do not immerse the coffee maker in
liquid.
Rinse the water reservoir occasionally
with cold water. Do not use a cloth as any
residue or lint may be left behind to clog the
coffee maker.
Remove the permanent filter, discard
used coffee and wash. Extended soaking
helps to remove coffee stains from the mesh.
Wash the glass jug, jug lid, and filter
holder in warm soapy water. Rinse and dry all
parts thoroughly. Refit filter and filter holder.
Wipe all external surfaces including the
warming plate with a damp cloth and dry
thoroughly.
Care must be taken to ensure that non-
drip valve situated on the bottom of the filter
holder is not damaged during cleaning.
Never use harsh or abrasive cleaners.
NO PARTS ARE SUITABLE FOR
CLEANING IN A DISHWASHER.
6
47039 rev1 7/2/06 8:45 AM Page 6

Helpline
If you have any difficulty with your
appliance, do not hesitate to call us. We are
more likely able to help than the store from
where you bought it.
Please have the following information
ready to enable our staff to deal with your
query quickly.
•Name of the product
•Model number and serial number as
shown on the underside of the appliance.
7
WEEE
For electrical products sold within the
European Community.
At the end of the electrical products
useful life it should not be disposed of with
household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice in your country.
47039 rev1 7/2/06 8:45 AM Page 7

Morphy Richards products are intended for
household use only.
Morphy Richards has a policy of continuous
improvement in product quality and design.
The company, therefore reserves the right
to change the specification of its models at
any time.
The After Sales Division
Morphy Richards Ltd, Mexborough
South Yorkshire, England, S64 8AJ
Helpline (office hours)
UK 0870 060 2610
Republic of Ireland 1800 409119
CM4709M UK Rev 1 01/06
Your two year guarantee
It is important to retain the retailers receipt
as proof of purchase. Staple your receipt to this
back cover for future reference.
Please quote the following information if the
product develops a fault. These numbers can
be found on the base of the product.
Model no. Serial no.
All Morphy Richards products are
individually tested before leaving the factory. In
the unlikely event of any appliance proving to be
faulty within 28 days of purchase it should be
returned to the place of purchase for it to be
replaced.
If the fault develops after 28 days and within
24 months of original purchase, you should
contact the Helpline number quoting Model
number and Serial number on the product, or
write to Morphy Richards at the address shown.
You may be asked to return a copy of proof
of purchase.
Subject to the exclusions set out below (see
Exclusions) the faulty appliance will then be
repaired or replaced and dispatched usually
within 7 working days of receipt.
If for any reason this item is replaced during
the 2 year guarantee period, the guarantee on
the new item will be calculated from original
purchase date. Therefore it is vital to retain your
original till receipt or invoice to indicate the date
of initial purchase.
To qualify for the 2 year guarantee the
appliance must have been used according to
the manufacturers instructions. For example
coffee makers should have been regularly
descaled.
EXCLUSIONS
Morphy Richards shall not be liable to
replace or repair the goods under the terms of
the guarantee where:
1The fault has been caused or is attributable
to accidental use, misuse, negligent use or
used contrary to the manufacturers
recommendations or where the fault has
been caused by power surges or damage
caused in transit.
2The appliance has been used on a voltage
supply other than that stamped on the
products.
3Repairs have been attempted by persons
other than our service staff (or authorised
dealer).
4Where the appliance has been used for hire
purposes or non domestic use.
5Morphy Richards are not liable to carry out
any type of servicing work, under the
guarantee.
6Plastic filters for all Morphy Richards kettles
and coffee makers are not covered by the
guarantee.
This guarantee does not confer any rights
other than those expressly set out above and
does not cover any claims for consequential
loss or damage. This guarantee is offered as an
additional benefit and does not affect your
statutory rights as a consumer.
•This guarantee is valid in the UK and Ireland
only.
47039 rev1 7/2/06 8:45 AM Page 8