5
www.morphyrichards.com
the item C.Press the shot-of-steam
button, this will create vertical steam.
•This feature is especially useful for
removing creases from hanging
clothes, curtains, wall hangings, etc.
•For optimum steam quality, do not
operate the shot more than three
times in succession.
Spray
Press the spray button ¤and aim
the spray of water at stubborn
creases. You can do this whilst dry
ironing providing there is water in the
tank. When using the water spray it
may be necessary to push the
button a few times to get the spray
pump primed.
No drip system
(certain models only)
Your iron is fitted with a no-drip
system which is designed to prevent
water escaping from the soleplate
when the iron is too cold.
• During use, the no-drip system may
emit a loud click, particularly during
heat-up or whilst cooling down. This
is perfectly normal and indicates
that the system is functioning
correctly.
Auto shut-off
(certain models only)
If the iron is fitted with the auto shut-
off function it will automatically shut
down after a set period.
• If the iron is left unattended in the
horizontal position it will shut down
after 30 seconds.
• If it is left in the vertical position it
will shut down after 8 minutes.
When this happens the two ‘power
on’ lights, located in the back cover
will flash to show that the iron is in
power-off mode.
To reactivate the iron gently shake it
until the ‘power on’ lights stop
flashing and remain on.
The iron will then start to heat back
up to the temperature it is set to.
Life long anti-scale
system (certain models only)
The life long anti-scale system
reduces scale deposits and helps
prolong the life of the iron.
Emptying and storing D
When you have finished ironing,
unplug your iron. Ensure that the
variable steam control is set at the
‘O’ position, lift up the fill cap and
empty any remaining water out of the
filling hole.
Do not store in the box, but in an
upright position, so that any drops of
water remaining cannot leak out and
discolour the soleplate.
IMPORTANT: The flex can be
damaged if wound too tightly around
the iron after use. Make a loose loop
with the flex and wrap it around the
iron. The iron must be cool before
winding the flex and storing on its
heel.
Cleaning
Jet cleaning
Your iron has a built-in cleaning
system designed to keep the water
valve, steam chamber and steam
vents clear of lint and loose mineral
deposits. Jet clean should be used
after each period of ironing.
1Ensuring that there is a little water in
the tank, place the iron on its heel
and turn the temperature control
dial to the maximum setting.
2Wait for the temperature indicator
light to go out, then unplug the iron
and hold it about 6" (150mm) above
the sink in the ironing position.
3Press the shot-of-steam button
about 10 times in succession.
4Empty out any remaining water.
WARNING: Do not attempt to
descale the soleplate with
descaling products.
g
