Mounting Solutions PAP-3DH User manual

Assembly Guide PAP-3DH
www.mnmounting.com
[email protected]om
2 Merezhna str., Bila Tserkva,
Kyiv region, 09100, Ukraine
SAFETY INSTRUCTIONS
1. Entrust mounting equipment only to experienced professionals and strictly follow the providedv safety instructions. Improperly
installed equipment may result in property damage, personal injury and/or liability for the installing contractor.
2. Only use appropriate fastening hardware.
3. Always make sure to securely use and lock all mounting bolts. Loose bolts may become unscrewed over time due to vibration
which will then create a safety hazard.
Assembly Guide for the bracket
PAP-3DH for the 3D system on
different Projector Pedestals

Assembly Guide PAP-3DH
www.mnmounting.com
[email protected]om
2 Merezhna str., Bila Tserkva,
Kyiv region, 09100, Ukraine
Assembly components:
1
Vertical bracket - 2 pcs
2
3
5
4
Horizontal bracket - 2 pcs
Left triangular bracket - 1 pcs
Right triangular bracket - 1 pcs
Plate with 4 nuts - 2 pcs
6
7
8
9
Plate with 2 nuts - 4 pcs
Nut M6 DIN 934 - 6 pcs
Screw M5x16 DIN 912 - 16 pcs
Screw M6x12 DIN 912 - 6 pcs
1
2
3
4
5
6
7
8
9
10
10
Side plate for PAP

Assembly Guide PAP-3DH
www.mnmounting.com
[email protected]om
2 Merezhna str., Bila Tserkva,
Kyiv region, 09100, Ukraine
1. Install the Horizontal brackets
on the Vertical brackets and fasten
them with Plates with 4 nuts and
screws .
2. You can adjust the installation
height of the Horizontal brackets
without removing them completely
from 10 mm to 383 mm. Set the height
you need and x the screws.
Assembly Instructions:
1
2
3
3. Install the Left and Right
Triangular Brackets on the Horizontal
Brackets and secure them with
Plates with 2 Nuts and Screws .
1
2
5
7
3
4
67
2
4. You can adjust the installation
width of the Triangle Brackets without
removing them completely from 272
mm to 572 mm. Set the width you
need and x the screws.
4

Assembly Guide PAP-3DH
www.mnmounting.com
[email protected]om
2 Merezhna str., Bila Tserkva,
Kyiv region, 09100, Ukraine
5. Install the assembled PAP-3DH
bracket on the side panel of the
pedestal . Fasten screws and
nuts securely!
5
6. Check the correct installation of
the bracket on the corresponding side
panel of the pedestal!
6
7. Install your 3D system on the
bracket PAP-3DH.
7
10
8
9