Movisens Move 4 User manual

movisens GmbH, Karlsruhe, Germany E-Mail: [e-mail]
Move 4
Physical Activity Sensor Quick Start Guide
Bedienungsaneitung
Move 4 Quick Start Guide English, Version 16.08.2018
Welcome
Thank you for choosing the Physical Activity Sensor
Move 4 from movisens. This sensor represents the
latest technology for the mobile monitoring of physical
activity in everyday life.
Description of the Sensor
Featuring an integrated Bluetooth Smart Interface, the
Move 4 expands researchers’ options by allowing
integration with the experience sampling platform
movisensXS.
The Move 4 captures specific parameters based on its
location on the body. The sensor can connect to our
range of textile accessories, or be worn with a clip at
the waist. A multi-colored LED provides visual
feedback on the sensors operation.
Scope of Application
The Move 4 captures physical activity (i.e. 3D
Acceleration, Angular Rate, Barometric Air Pressure…)
and other secondary parameters of a test subject.
It’s been designed and tailored for research and
scientific applications with a 4 week recording capacity.
Software Installation
Before starting a measurement, you have to install the programs on the USB stick.
SensorManager: Configures the sensor, starts a measurement
and downloads the data from the sensor
UnisensViewer: Views and preprocesses the stored data
DataAnalyzer: Analyzes the stored sensor data (30 days free trial version)

movisens GmbH, Karlsruhe, Germany E-Mail: [e-mail]
Move 4
Physical Activity Sensor Quick Start Guide
Bedienungsaneitung
Move 4 Quick Start Guide English, Version 16.08.2018
Handling
Charge the Sensor
Connect the sensor to a USB port until the LED is blinking green.
During charging, the status LED is blinking blue.
Start SensorManager
Connect Move 4 to the PC, click on “Start Recording” and configure
the measurement parameters.
Attach the Sensor
Choose the sensor location from the available
options. Be aware that some parameters can only be
calculated in specific positions. Don’t connect the
sensor to a PC during measurement, this will stop it!
Start SensorManager
After the measurement, connect the Move 4 to the PC, click on
“Save Data” and enter the required information.
Start UnisensViewer
Click on “Show data” directly after storing the data.
Start DataAnalyzer
Select the desired analysis output to calculate secondary parameters
or to generate reports.
Please read the User Manual for further details !
Configure and start
the measurement
Measure
Read out and store
the data
Analyse the data
SensorManager
UnisensViewer
SensorManager
DataAnalyzer
UnisensViewer
results: .csv, .pdf, .xlsx
View and preprocess
the data
Prepare the sensor