MPC SUPERSNAP MERCURY 1950 User manual

NOTE: If the fit of the Antenna
or Siren vis tight, slowly work
the parts into their locating
holes.
NOTE: For ease of applying decals,
they are separated on the sheet.
For the experienced modeler, you
may still use a modeler’s knife and cut
close to the images, and for the novice
you can cut them apart with scissors.
When applying decals, be sure to
follow the instructions exactly as written.
(See back of decal sheet.)
Repeat for other side.
RED CLEAR
COLORED: 99 on down • CHROME: 100 on up
105
44
45 45
106
44
109
109
42
41
102
101
107L
107R
108
108
104
103
100
112
114
111
110
113
Ford Oval and nameplates are registered trademarks owned and licensed by Ford Motor Company. Manufactured by Round 2, LLC. www.ford.com Goodyear (and wing foot design) are trademarks of Goodyear Tire & Rubber Company, Akron, Ohio USA used under license by Round 2, LLC. MPC & design is a registered trademark of Learning Curve Brands, Inc.
used under license to Round 2, LLC. ©2009 Learning Curve Brands, Inc. All rights reserved. ©2009 Round 2, LLC, South Bend, IN 46628 USA. Product and packaging designed in the USA. Made in China. All rights reserved.

ASSEMBLY TIP: Place the window unit over the locating
posts in the body and press lightly until it is fully seated.
Now, hook the rear locating holes of the interior over the
rear posts in the body, then CAREFULLY bend the front
posts back SLIGHTLY until they fit through the front holes
of the interior. With all four posts through the holes, press
the interior into place.
ASSEMBLY TIP: Work the mounting pegs as far as
possible into locating holes of chassis. Slide holes
in rear of body over pegs at rear of chassis. Carefully
spread body to fit over chassis and align pegs into
mounting posts of body. Carefully press body and
frame together until body is fully seated onto frame.
To notches in interior floor
NOTE: Chassis shown upside down for clarity.
CLEAR
NOTE: Long Hubs are used
on Front Wheels.
To holes in rear of body
1
46
18
17
20
19
43
43
46