MPC The Dukes Of Hazzard M706-200 User manual

Do Not Cement
4
10
2
1
11
3
NOTE: Refer to box cover illustration for additional
information on decal location.
Before you begin building your kit, read the in-
structions and study the illustrations carefully.
Test fit the parts before cementing them together,
to acquaint yourself with their proper location.
It is best to cut the parts from the "runners" with
a modelers knife instead of twisting them off. Cut
the parts only as they're needed. Only paint and
cement made for styrene should be used. Trim
off excess plastic or "flash". The plating should
be scraped from chromed parts where they are to
be cemented. Use cement sparingly. Apply ce-
ment to small parts with a toothpick. When paint-
ing your model it is best to cement all non-chro-
med parts to the body and paint the whole unit
at one time.
IMPORTANT! READ THESE INSTRUCTIONS FIRST.
THE DUKES OF HAZZARD
General Lee DODGE CHARGER
STEP NUMBER FOR
CHROMED PARTS
STEP NUMBERS FOR
NON-CHROMED PARTS
PART NUMBERS
10
37
10
CEMENT
DO NOT CEMENT
CLEAR
PLASTIC PARTS CLEAR
RED CLEAR
PLASTIC PARTS RED CLEAR
124
1
229
Do Not Cement
FRONT (2X)
14
REAR (2X)
15
17
Repeat for other side.
OPTIONAL DUAL-CARB SETUP
107
109
109
109
3
46
5
24
25
21
8
23
5
16
18
2
12
Repeat for other side.
108
7
10 11
28
20
19
9
NOTE: For ease of applying your decals, they are separated on the sheet.
For the experienced modeler, you may still use a modelers knife and cut close to the image,
and for the novice you can cut them apart with scissors.
When applying decals,
be sure to follow the instructions
exactly as written on back of
decal sheet.
M706-200
THE DUKES OF HAZZARD and all related characters and elements are trademarks of and © Warner Bros. Entertainment Inc.
WB SHIELD: TM & © Warner Bros. Entertainment Inc.
(s09)
Dodge and HEMI® are trademarks of Chrysler LLC. Dodge Charger and its trade dress are used under license by Round 2,
LLC. © Chrysler LLC 2009. Goodyear (and wing foot design) are trademarks of Goodyear Tire & Rubber Company, Akron, Ohio
USA used under license by Round 2. MPC and design is a registered trademark of Learning Curve Brands, Inc. used under
license to Round 2, LLC. ©2009 Learning Curve Brands, Inc. All rights reserved. ©2009 Round 2, LLC, South Bend, IN 46628
USA. Product and packaging designed in the USA. Made in China. All rights reserved.

3
Repeat for other side.
(Use with Optional
Dual Carb Setup)
OR
8
Repeat for other side.
DO NOT CEMENT
assembled roll cage
into interior.
Roll cage optional.
36
1
2
4
5
METAL AXLE
3
22
45
2
13 1
4
12
11
10
51
8
9
54
53
51
9125
BODY 6
5
Repeat for other side.
8
1
7
4
2
Repeat for other side.
64
100
102
65
101
3
CLEAR
RED CLEAR
CLEAR
118
3
63
7
112
5
9
34
2
14
5
6
OPTIONAL