INTRODUCTION
Your charger is fully controlled by a microprocessor and is suitable for automatic recharging of gel batteries. For best results and
safety, the user is required to read, follow and keep these instructions carefully. This device is to be used exclusively for rechar-
ging gel batteries of the voltage and capacity indicated in the paragraph entitled BATTERY. The manufacturer is not responsible
for any damage due to improper use. This device is designed for use only in environments that are protected from any atmosphe-
ric disturbance.
BATTERY
This charger should be used to charge batteries that have the following characteristics:
• battery type: gel or internal recombination batteries
• rated voltage: see rating data on rectifier (e.g. 24 Volt)
• capacity: the optimum value can be calculated on the basis of rated rectifier current In (see rating plate):
In = 8A capacity will be C = 40 ÷ 65 Ah
In = 5A capacity will be C = 25 ÷ 40 Ah
INSTALLATION
To ensure maximum safety, the installation has to be carried out as indicated by the manufacturer. Installation and any work on
the rectifier must be carried out by qualified technical personnel. Install only after disconnecting the supply cable from the mains
power supply and the output cables from the battery. After unpacking, ascertain that the device is in perfect condition. In case of
doubt, do not use the device and contact the supplier. Install the charger in a protected place; do not install it:
• outdoors or in open sheds;
• in any damp or dusty place or in presence of acids;
• in any place with temperatures below 0 and above 40°C (32 and 104° F);
• in any place that is in any way unsuitable for electronic devices.
Do not obstruct the ventilation apertures and do not cover during operation.
POWER SUPPLY
Ascertain that the rating plate values are compatible with your mains power supply (mono-phase, voltage, frequency, power).
Plug it into a tap that is equipped with protection that complies with standard regulations. If you have to use an extension cable,
contact the manufacturer for correct technical information. The supply cable must be replaced only by qualified personnel.
GENERAL RECOMMENDATIONS
Do not let the battery run down completely. If recharged when only partially discharged, the battery will last longer and the recti-
fier will do a better job. Prevent oxidation of the battery contacts. Never disconnect the battery if the rectifier is supplying current
as the break-off spark could ignite the gases produced by the battery. Keep the charging area ventilated.
MAINTENANCE
The rectifier does not require any maintenance. For cleaning the outside, use a damp cloth. Use manufacturer approved spare parts.
INSTRUCTIONS FOR CHARGERS
EASY-GOLF serie
