MREL MicroTrap User manual

QUICK START GUIDE
1
2
3 4
A: UNLOCK THE LATCHES.
B: OPEN THE MICROTRAP™.
INSTALL THE MICROTRAP™ SOFTWARE
ON THE COMPUTER.
A
A
B
A
B
TURN ON THE MICROTRAP™ BY TOGGLING
THE ON / OFF SWITCH AS SHOWN. THE
STATUS LIGHT WILL BEGIN TO FLASH.
PRESS THE BATTERY STATUS BUTTON TO
CHECK THE BATTERY LEVEL OF THE
MICROTRAP™.
PLUG THE COMMUNICATIONS CABLE INTO THE
MICROTRAP USB COM PORT.
THE LED WILL LIGHT UP INDICATING
THE LEVEL OF BATTERY AVAILABLE.
IN THE ABOVE EXAMPLE, THE
MICROTRAP™ IS AT 90%. IF THE
BATTERY LEVEL IS TOO LOW, PLEASE
SEE STEP 6 TO RECHARGE
MICROTRAP™, ELSE GO TO STEP 7.
PLUG THE BATTERY CHARGER INTO THE DC IN/OUT
CONNECTOR ON THE MICROTRAP™. PLUG THE OTHER
END OF THE BATTERY CHARGER INTO AC MAINS.
A: PRESS THE TOTAL TESTS BUTTON TO
VIEW THE TOTAL TESTS AVAILABLE ON
THE MICROTRAP™.
B: PRESS THE REMAINING TESTS BUTTON
TO VIEW THE REMAINING TESTS
AVAILABLE ON THE MICROTRAP™.
5 6 7
8
PLUG THE OTHER END OF THE
COMMUNICATIONS CABLE INTO THE
COMPUTER WITH THE MICROTRAP™
SOFTWARE INSTALLED. LOAD UP THE
MICROTRAP™ SOFTWARE AND CLICK THE
HIGHLIGHTED BUTTON ABOVE TO PROGRAM
THE MICROTRAP™.
9
WHEN THE ABOVE WINDOW APPEARS
CHOOSE THE TYPE OF TEST YOU WISH
TO PERFORM. IN THIS EXAMPLE, WE
CHOOSE VOD.
10

11 12 13
USING THE ABOVE WINDOW THAT OPENS,
SETUP THE MICROTRAP™ AS NEEDED. WHEN
FINISHED CLICK THE CHANGE SETTINGS BUTTON .
A: IF USING THE MICROTRAP™
INTERNAL TRIGGER MAKE
SURE THE TRIG EXT/INT
SWITCH IS IN THIS POSITION.
B: IF USING AN EXTERNAL
MANUAL TRIGGER, MAKE
SURE THE TRIG EXT/INT
SWITCH IS IN THIS POSITION.
PRESS THE NEXT TEST BUTTON. STATUS LIGHT
WILL STOP FLASHING AND WILL REMAIN
ILLUMINATED (ACTIVE MODE).
WHEN READY TO CAPTURE THE VOD FOR THE
EXPLOSION, PRESS THE START BUTTON.
THE START LIGHT WILL REMAIN ILLUMINATED.
14
17
A: CONNECT THE COAXIAL CABLE TO THE VOD
CONNECTOR ON THE BACK OF THE
MICROTRAP™.
B: IF USING A MANUAL TRIGGER, CONNECT THE
TRIGGER TO THE EXT TRIG CONNECTOR.
SETUP THE VOD PROBEROD
OR PROBECABLE AS
NEEDED FOR YOUR TEST.
CONNECT THE PROBEROD
OR PROBECABLE TO THE
COAXIAL CABLE USING
WIRECUTTERS AND
ELECTRICAL TAPE.
18 19
WHEN THE MICROTRAP™ HAS BEEN
TRIGGERED AFTER THE EXPLOSION,
THE TRIG’D LIGHT ON THE OUTSIDE
OF THE MICROTRAP™ WILL BEGIN TO
FLASH.
PLUG THE COMMUNICATIONS CABLE
INTO THE MICROTRAP USB COM PORT.
CONNECT THE OTHER END OF THE
COMMUNICATIONS CABLE TO THE
COMPUTER AND DOWNLOAD THE
VOD RESULTS.
1615
A
A B
B