MSD 6ALN for Dirt Race Series
PN 64316
Parts Included:
1 - Ignition Control 1 - 2-Pin Deutsch Wiring Harness
1 - 6-Pin Deutsch Wiring Harness 4 - Vibration Mounts
MOUNTING
The Ignition can be mounted in any position and may be mounted in the engine compartment,
however, it should be kept clear of direct engine heat sources. Use the Ignition as a template to mark
the location of the mounting holes. Using 3/16" drill bit, remove the ignition and drill the holes. Install
the vibration mounts and the ignition.
WIRING
Figure 1 shows the position, color and function of each wire.
Triggering
The MSD can be triggered by points, amplifier, or with a magnetic pickup.
Points: The single White wire of the MSD is for points triggering. It connects to the points/amplifier
output wire of the distributor.
Magnetic Pickup: The Magnetic Pickup wires are in the 6-Pin connector. The Mag positive (+) wire
is Violet, the Mag Negative(-) is Green. They are in the terminals marked "3" and "4".
ORANGE
BROWN
GREEN
VIOLET
RED
BLACK
(+) COIL
TACH
(-) MAG
(+) MAG
(+) 12V
(-) COIL
6
5
4
1
2
3
BLACK
RED
VIO
ORG
BROWN
GREEN
Figure 1 The Color, Function and Position of Each Wire.
IMPORTANT: Read instuctions thoroughly before attempting installation.
This Ignition Control is designed as a spec ignition for the Dirt Motorsports Race Series. It features
a fixed 7.600 rpm rev limit and is set for 8-cylinder use only.
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for!
