Mueller HealthyStone FP-10 User manual

BEFORE FIRST USE
1. Check the surface and the bottom of the pan for any scratches or
other damages that may have occurred during transportation.
2. Using warm water and dish soap, wash the pan to remove any dirt
from the factory and any packaging residue.
3. Dry the pan thoroughly with a clean dishcloth or paper towel.
4. Season a non-stick pan by rubbing 1 teaspoon of olive or canola
oil onto the surface of the pan all the way up to the rim.
5. Heat the pan on the stove over medium heat for 30 seconds.
ATTENTION: Do not overheat the pan, whether it is empty or not. The
non-stick properties of a coating may wear off, and the bottom may
become warped.
6. After heating the oil, wipe out any excess oil with a clean dishcloth
or paper towel. This helps maximize the surface performance and
longevity of the pans.
GENERAL GUIDELINES FOR USE
• Never leave cookware unattended while cooking.
• Use only low to medium heat with your pan at all times. This pan
conducts heat extremely quickly and evenly. High heat may damage
your stone cookware.
• Select the proper burner size so that the heat touches only the
bottom diameter of the pan and not its sides.
• When cooking over a gas burner, make sure the flame touches only
the cookware bottom cooking surface. If the flame comes up the
sides of the pan, energy is wasted, and the sides of the pan may
become permanently discolored.
The fry pan is oven safe up to 446 F°/ 230°C
• Never leave an empty pan on a heated burner.
• Do not use the pan to flambe.
• Do not slide or drag the pan across the stovetop, as this may cause
damage to both the pan and the stovetop.
• Never cut food directly in the pan or gouge the surface in any way.
• Use ONLY wooden, silicone, or plastic utensils with this pan to pre-
vent damage to the coating.
• The pan surface may become slightly darker with use. Slight surface
marks or abrasions are normal and will not affect the performance of
the non-stick coating.
CLEANING AND CARE
• Allow non-stick coating to cool before cleaning.
• Hand wash in hot water with mild detergent using a cloth or sponge
and let air dry immediately to preserve appearance. Always scrub in
the direction of the material grain.
• Never use abrasive cleaners, metal scouring pads, oven cleaners, or
strong solvents.
• To remove food burnt to the bottom of the cookware, boil a mild
solution of vinegar and water for 10 minutes to dislodge food parti-
cles.
• To remove white film caused by starch or water minerals, rub with a
sponge that has been dipped in lemon juice or vinegar, then wash with
hot, soapy water.
HealthyStone 10" Fry Pan
Model: FP-10
Long lasting premium non-stick performance without the dangerous
chemicals from this German stone-based pan coating. It's 100% free
of APEO, PFOS, PFAS, PFOA, PFBS, GenX, and other less known
health-harmful chemicals, such as NEP and NMP.
The sturdy construction material prevents vibrations and increases
durability, while its ergonomic design will make your healthy cooking
even more enjoyable.

BEFORE FIRST USE
1. Check the surface and the bottom of the pan for any scratches or
other damages that may have occurred during transportation.
2. Using warm water and dish soap, wash the pan to remove any dirt
from the factory and any packaging residue.
3. Dry the pan thoroughly with a clean dishcloth or paper towel.
4. Season a non-stick pan by rubbing 1 teaspoon of olive or canola
oil onto the surface of the pan all the way up to the rim.
5. Heat the pan on the stove over medium heat for 30 seconds.
ATTENTION: Do not overheat the pan, whether it is empty or not. The
non-stick properties of a coating may wear off, and the bottom may
become warped.
6. After heating the oil, wipe out any excess oil with a clean dishcloth
or paper towel. This helps maximize the surface performance and
longevity of the pans.
GENERAL GUIDELINES FOR USE
• Never leave cookware unattended while cooking.
• Use only low to medium heat with your pan at all times. This pan
conducts heat extremely quickly and evenly. High heat may damage
your stone cookware.
• Select the proper burner size so that the heat touches only the
bottom diameter of the pan and not its sides.
• When cooking over a gas burner, make sure the flame touches only
the cookware bottom cooking surface. If the flame comes up the
sides of the pan, energy is wasted, and the sides of the pan may
become permanently discolored.
The fry pan is oven safe up to 446 F°/ 230°C
• Never leave an empty pan on a heated burner.
• Do not use the pan to flambe.
• Do not slide or drag the pan across the stovetop, as this may cause
damage to both the pan and the stovetop.
• Never cut food directly in the pan or gouge the surface in any way.
• Use ONLY wooden, silicone, or plastic utensils with this pan to pre-
vent damage to the coating.
• The pan surface may become slightly darker with use. Slight surface
marks or abrasions are normal and will not affect the performance of
the non-stick coating.
CLEANING AND CARE
• Allow non-stick coating to cool before cleaning.
• Hand wash in hot water with mild detergent using a cloth or sponge
and let air dry immediately to preserve appearance. Always scrub in
the direction of the material grain.
• Never use abrasive cleaners, metal scouring pads, oven cleaners, or
strong solvents.
• To remove food burnt to the bottom of the cookware, boil a mild
solution of vinegar and water for 10 minutes to dislodge food parti-
cles.
• To remove white film caused by starch or water minerals, rub with a
sponge that has been dipped in lemon juice or vinegar, then wash with
hot, soapy water.
Müeller USA
168 Mason Way Unit #4A,
City of Industry, CA 91746
Telephone: [phone]
E-mail: [email protected]
Web: www.muellerdirect.com