Multi Trolley StepGlider User manual
StepGlider
Multi Trolley
Contents
The following parts are included in your StepGlider package:
•2x StepGlider skids
•4x Frame posts (46 cm)
•4x Frame posts (64 cm)
•8x Frame post mounting brackets
•16x Hex socket (Allen) head screws
•1x Hex (Allen) key
See pictures for help with construction:
Assembly
•Measure the width of the object that you wish to transport.
•Select either the 46 cm or the 64 cm frame posts.
•Using the Hex (Allen) key, adjust the width of the SG so that the object
overlaps. SG must not overlap the object.
•Avoid loading any weight on the red frame posts, the weight should be on
the rubber strips on the SG.
•Attach straps to secure the load. Depending on the object, it is usually best
to attach SG and secure whilst in the upright position.
•Lower SG to the floor and attach straps to any of the red mounting
brackets either side of the SG skids. Simply pull the straps in the direction
wished. (check multitrolley.com to see the video of SG in use).
Important notice: before use of StepGlider, please ensure that any user has read the instructions and
understands the method used. It is important to be aware of where the weight is concentrated and
to have control at all times to avoid injury.
Please refer to manufacturer (www.multitrolley.com) with any questions.
PRODUCT OF SWEDEN
(+46) 19 27 27 32 |info@multitrolley.com |www.multitrolley.com
MULTI TROLLEY AB ·NASTAGATAN 2 ·702 27 ÖREBRO ·SWEDEN
Table of contents
Other Multi Trolley Outdoor Cart manuals
