
PR-004
Warning
Never touch the rotating part of the motor while operating.
The failure could result in injuries.
Take a measure for safety to keep away contact by personel.
Do not touch the motor and driver while power is ON or for some time after
power-OFF.
Temperatures may be high and you may get burnt.
Do not change the wiring while power is ON.
Be sure to remove wiring and unplug a connector after power-OFF.
The failure could result in electric shocks, runaway or damages.
Do not give damage to, apply excessive force to, place something heavy upon,
or pinch the cable.
Do not pull the cable by too much power. The failure could result in damages to connection
section, or electric shocks.
Never disassemble, modify, or repair the product.
Do not open the cover of the product, or disassemble or modify the parts inside.
The failure could result in re, electric shocks, malfunction or injuries.
Do not install the product on or near combustibles.
Attach the product to noncombustible matter such as metal. The failure could result in re.
Do not tamper with water, corrosive gas, inammable gas, ammable
material, or electrically conductive material such as screw or metal piece.
Do not insert metal pieces into the venting holes of enclosure.
The failure could result in re, electric shocks, or damages.
Be sure to ground the terminal of the earth wire.
Securely ground to prevent electric shocks and to stabilize the potential in the control circuit.
Caution (environment)
Keep or use the product under the following environmental conditions.
Ambient temperature / Working : 0 to 40 , Storage : -20 to 60 (non freezing)
Ambient humidity : Below 90%RH (non condensing)
Vibration / Shock resistance : Below 9.8ms-2 (1G) / Below 98ms-2 (10G)
Avoid store or use in such an environment where the product is exposed to oil or water.
(It is not waterproof structure.)
Indoor use only (no direct sunlight). No corrosive gas, inammable gas, oil mist or dust.