MUX Wall Socket User manual

www.mux.life
Wall Socket
Product and Installation Guide

Product Overview
- App Control
- Voice Control (compatible with Amazon Alexa and Google Assistant)
- Smart Scheduling and Automation
- Timers
- Smart Scenes
- Real time status notification
- Remote Management
Features
Refer to the following steps for the installation of the Mux Wall Socket.
Installation and Wire Connection
Pre-Requisite for Installation
- A neutral wire.
- Two inches deep Sub-box.
- Electrical Tester.
- Screw Driver.
- Screw Nuts (available with the product).
- Electrical box dimensions 3.3x3.3x1.5 inches.
Mux Wall Socket is a Wi-Fi enabled smart device, which allows you to plug and
control any electronic appliance via the Mux Life App. Additionally you can set
timers, apply schedules and control the devices via virtual assistants. Detailed
statistics help you monitor the usage of your devices.

Socket
Power Button
LED light
Front Side
Back Side
Live / Hot Wire
Screw
Neutral Wire

Switch off the circuit breaker of the
respective room.
Use an electrical tester to confirm if electric
current is passing through.
Step 1
If you have met the above electrical requirements, proceed with the installation:
Unscrew and Remove existing wall socket.
Step 2

Step 3
Step 4
Connect the Smart Device to your sub-box wiring as mentioned in the table.
N - Black Wire
L - Red Wire
Identify Live, Load, Neutral and Ground lines.

L
Live / Hot Wire
Neutral Wire N
Mux Wall SocketSub-box Wiring
The table mentions sub-box wiring details.
Step 5
Fix the Smart Device to the wall and look for
the LED status.
For the LED status, see the table on next
page.

To put the device in reset mode, press and hold the power button on the device for 6
seconds (until the blue LED starts flashing). The device is now in reset mode. You
can now add it to your Mux Life account.
Reset Device
Fast Blink (< 0.5 sec)
Slow blink (1 sec)
Stable ON
LED Light LED Status Wifi Status Description
Device in
Broadcast Mode
You can add the
device into your Mux
account after
resetting it.
Very fast blink
(0.03 sec)
Device already
added in mux life
account and looking
for the saved Wi-Fi.
Check the power
connection of your
Wi-Fi routers where
the device was
connected.
Device connected
to Wi-Fi but has no
internet access
Check internet
connection on the
Wi-Fi Router where
device is connected.
Device can perform all
actions.
Device correctly
configured
Product LED Status
Blue Light

Scan the QR code to watch an installation video to setup Mux Life App.
App Setup
Caution
- Wrap electrical tape around the wire nuts to make sure the copper conductor is
fully concealed.
- Do not install the Smart Device with wet hands or when standing on wet or
damp surfaces.
- If you cannot find out a Neutral Line in your power line socket, consult with a
professional electrician or contact our service team.
Download the Mux Life App from the Google Play / App Store or scan the QR code.
App Download