MyBones Marodyne LiV User manual
SETsquared Bristol, Approach Road, Temple Meads, Bristol, BS1 6QH
V1 –13/01/2022
Before using your Marodyne LiV device, please read and familiarise yourself with the ‘Instructions for Use’
guide packaged with your device
1. Set Up
•Place your device on a dry, hard and level floor (e.g. a tile/stone floor or a thin carpet)
•Ensure the device is positioned where you intend to use it. Once the device is powered on, it
must not be moved
2. Power Assembly
•Connect the power cord into the switching adaptor
•Plug the power cord into the back of the device
•Connect the AC power plug into a mains power socket. A green light will display on the
switching adaptor to indicate the device is receiving power
•Switch the device on using the rocker switch located at the back of the device. A blue light
will signal it is successfully switched on
3. Getting Started
•When first switched on, the device will undergo a series of light cycles as it calibrates
•Once the calibration is complete, the word ‘Go’ will display on the device and a beep
indicates it’s ready for use. A single green light at the centre of the feet indicates the device
is in standby mode, and you can begin your session
QuickStart Guide
Marodyne LiV
SETsquared Bristol, Approach Road, Temple Meads, Bristol, BS1 6QH
V1 –13/01/2022
4. LiV Session
•Do not wear shoes while using the device. Socks are permitted
•Step onto the device and place your feet about a shoulder width apart. It is recommended to
stand on the device so that your big toes are in line with the bottom of the Marodyne LiV
logo
Correct foot placement
•Once you step onto the device it will start to vibrate gently
•When you are standing correctly on the device you will feel the gentle vibrations in your jaw
•A timer on the device’s display will count down from 10 minutes to indicate how much time is
left of your session
•If you step off the device the timer will automatically pause. You have 5 minutes to step back
onto the device before the timer resets and the device re-enters standby mode
•An orange light on the display indicates you need to correct your balance. An alarm may
sound, but there is no need to step off the device. If you do not correct your balance, an
‘Eror’ message will appear on the display. To restart the device, turn the rocker switch at the
back of the device off and on again
•The device will emit a short beep when your 10-minute session is complete
5. Finish
•Once your 10-minute session is complete, step off the device
•The device will then automatically enter a standby mode
Do not attempt to move the device whilst it is in standby mode. Please ensure that your Marodyne LiV
device is turned off at the rocker switch first**
Always ensure you turn your Marodyne LiV device off using the rocker switch first before switching it off at
the wall
** if you have moved the device whilst in standby mode, please switch it off on the rocker switch,
and then switch if off at the wall. Leave the device for 15 minutes before turning it back on.
SETsquared Bristol, Approach Road, Temple Meads, Bristol, BS1 6QH
V1 –13/01/2022
Quick Troubleshooting & FAQs
Should I wear shoes?
You should not wear shoes while using the device
How do I know I am on the device correctly?
A single green light in the centre of the display will indicate you are positioned correctly. You
should be able to feel the vibrations all the way up to your jaw
My device has stopped mid-session, what should I do?
Try shifting your weight from side to side or rocking gently back and forth onto the balls of your
feet to restart the vibrations. If you remain completely still for too long, the sensors inside the
Marodyne LiV device may interpret that you have stepped off and will pause the session to
conserve energy. Alternatively, you may need to stand slightly further forward on the device to
ensure your weight is correctly positioned over the sensors. It is important that your feet are
positioned either side of the display
What do the yellow lights on the display indicate?
The yellow lights indicate that you may be spreading your weight unevenly. You can use the lights
to show you how to adjust. See the figure below for an explanation of what each light indicates:
Why do the vibrations feel weaker when I adjust my stance on the device?
The device may reduce the intensity of the vibrations it emits if it detects your balance is off-
centre. To receive the optimum level of vibration, ensure your balance is centred with your feet
placed evenly apart
Why is my device making a rumbling noise?
Incorrect posture or balance may cause the device to emit a mechanical rumbling noise. To stop
the noise, adjust your posture and balance slightly
How should I store my device?
Marodyne LiV should be stored flat with its feet facing down
User is leaning
or standing too
far to the right
User is leaning or
standing too far
to the front
User is leaning or
standing too far
to the left
User is well
positioned
User is leaning or
standing too far
to the rear
Table of contents
Other MyBones Medical Equipment manuals
