NASA electric NS-1114 User manual
NS-1114
NS-1114
Stand Fan
NS-1114
Stand Fan
4
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
5
.
.
L
NS-1114
Stand Fan
6
L
.
“OFF .
.
ON
SPEED
III II I
mode
STANDBY
.
OSCILLATION
.
.
STANDBY
.
.
7
:ON/SPEED
SPEED
OFF
OFF
OSC
OSC
MODE
MODE
TIMER
.
•
NS-1114
Stand Fan
8
-
.
7
cut off.
3. Be careful not to spill water on the fan
or into the fan housing.
4. Always use a soft and wet cloth
soaked in mild detergent.
5. Do not use any of the following
materials for cleaning: Gasoline, thinner
and etc.
6. Do not attempt to repair the device
yourself in the event of a technical defect
or doubt, as this may result in a risk of fire
or electric shock.
Cleaning
wet cloth. Do not try to remove the fan
blades.
around the engine compartment. The
motor or other electrical parts of the
device should not come into contact
with water.
Maintaining
Be sure to switch off the power supply
and pull out the plug before cleaning.
1. This machine only needs common
external cleaning and wiping.
2. Place into casing and store in the dry
position.
Power 60W
Frequency 50Hz
Voltage 220-240V˜
Correct Disposal of this product
This marking indicates that this
product should not be disposed
with other household wastes
throughout the EU. To prevent
possible harm to the environment, or human
health from uncontrolled waste disposal,
and re-cycle it responsibly to promote the
sustainable re-use of material resources.
To return the used device, please use the
use the return and collection systems, or
contact the retailer where the product was
purchased. They can take the product for
safe environmental re-cycling.
Guarantee and after sales service
This device has 18 month guarantee and
5 years after sales service, for more
information about guarantee and after
sales service condition please read the
guarantee sheet in the end of this user
manual.
Technical Specifications
NS-1114
Stand Fan
6
All you have to do is press the “STAND-
BY” button to turn off the fan.
4. To increase the wind area inside the
room, press the “OSCILLATION” button,
then the fan will oscillate and the wind
will blow in a wider area of the room.
To exit this mode, all you have to do is
press the same button again. Moving the
fan head up or down will change the di-
rection of the wind.
5. To turn off the fan completely, set all
the buttons to “STANDBY” mode and
unplug the plug.
Instructions for using the remote
control
1
of the remote control.
2. The remote control, controls all
the functions of the base part for
easy performance. Follow the basic
instructions for remote control of the
fan.
Note: Do not use the old battery with the
new battery.
3. Please remove the batteries when
you are not use the fan for a long time.
Setup the fan
ON/SPEED switch
The wind speed will be change from 1 to
6, for this you can press SPEED button
repeatedly, the speed will be change. in
speed of 6 if you press SPEED button
one more time, it will turn back to speed
1 again.
2. OFF switch
Press the OFF switch to turn the device
off.
3. Oscillating
Press the OSC button and the head
starts to rotate, then press it again, the
fan will stop rotating.
4. MODE switch
There are three mode: normal, natural
and sleeping. You can change the wind
mode by pressing mode button repeat-
edly
5. TIMER switch
The fan can work at 30mins, 60mins,
120mins and 240mins by setting the timer.
Remarks: The function of Item 2,3,4,5
are also can be realized by remote
control.
Manual setting of wind direction
The angle of the fan head is adjustable,
it can facing upwards and downwards by
slightly lift or press the cover.
Troubleshooting
When starting the fan, the fan blade
doesn´t work, please check whether the
power plug has really inserted into the
socket or the cover has distorted, which
has touched the fan blade. If sound
the noise when starting the fan, please
check the unit as following:
1. Fan blade has been tight installed into
the output shaft of motor.
2.Groove on back of cover has matched
the inserting groove on the output shaft.
3. There are tiny defective edge ring
existing around the fan blade.
4. The cover has distorted, which has
touched the fan blade.
Cleaning and maintenance
For safe care of the device, please keep
in mind the following safety tips:
1. Always unplug the appliance before
cleaning it and wait for it to stop
completely.
2. Before removing the guard, make
sure that the power supply to the fan is
5
20. While cleaning, be sure to not splash
Assembly Instructions
The fan is packaged with its grills un-at-
tached. You must attach the grills before
operating the fan.
Warning: Never operate the fan without its
foundation and other parts. The fan must
only operate in the up-right position, and
any other position will be hazardous.
Do operate the fan only in upright position;
any other position could create a hazard-
ous situation.
Assemble the foundation and other parts
of the appliance in the following sequence:
1.
.
2. Loosen the retaining screw to Lifting
Lifting
bar-
ing screw.
3.
-
4.
5. -
wise direction until it is completely tight.
6.
7.
counterclockwise until it is fully secured.
8.
9.
the front and back nets, and tighten the ring
Using the device
1. Before using the device, make sure
that it is on a flat and stable surface. If
the device is placed on a sloping surface
damage is possible.
2. Set all buttons to “OFF” and then plug
directly into the standard AC outlet.
Make sure the plug is completely insert-
ed into the socket.
3. Press the “ON” button on the con-
troller to start the device. To select the
1 Front grill Fan head Lift pole
2 Grill ring 10 Connection pole 18 Stand post
3 Fasten nut for fan leaf 11 Control box Heavy base
4 Fan leaf 12 Locknut for control box 20 Press plate
5Fasten nut for back grill 13 Locknut for Lifting 21 Bend bolt
6 Back grill 14 base 22 Grill ring screw
Motor shaft 15 Control panel
8 Motor shaft pin 16 Touch switch
NS-1114
Stand Fan
4
Structure and Parts
water and do not use oil, alcohol or chem-
ical articles as they may cause distortion
of fan body and cause electrical hazards.
21. Do not pull out the power supply plug
by pulling power supply cord, which may
lead to electrical shock or generating
electrical shock.
22. Keep away from curtain, closing or oth-
er something may affect the fan’s working.
23. Turn off all switches and pull out power
supply plug when you go out for a long time.
24. Never use the fan before finishing as-
sembly to avoid any hurts.
25. Before sending for maintaining the
certified NASA Electric after sales service
centers, if the unit doesn’t work, please
check the plug of power supply has been
inserted into socket with electricity.
26. Cleaning and user maintenance shall
not be made by children with supervision.
27. Ensure that the fan is switch off from the
supply mains before removing the guard.
1
2
86
53
18
10
4
20
21
14
11
12
15
16
13
22
3
Safety warnings
Read these instructions for use carefully
and keep it well.
Warning: To reduce the risk of fire, elec-
trical shock, and injury to person, the fol-
lowing must be adhered to:
1. Before Plug in the socket make sure the
voltage of home socket is match with this
product.
2. This appliance is not intended for use by
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the ap-
pliance by a person responsible for their
safety.
3. Children should be supervised to ensure
that they do not play with the appliance.
4. This appliance is intended for home use
and the following:
- stores, offices and other workplaces.
- garden houses.
- Hotels and motels.
- places where bed and breakfast facilities
are available.
5. Connect the appliance to a sin-
gle-phase AC supply voltage, specified
on the rating plate.
6. Never leave the fan un-attended while
it is in use. Always turn the fan to the
“OFF” position, and unplug the fan from
the electrical outlet socket, when not in
use.
7. Extreme caution is necessary when any
fan is used by or near children, invalids or
elderly persons, and whenever the fan is
left operating un-attended.
8. Never use the device in the neighbor-
hood of firebug or explosive materials.
9 . Do not use a fan without a stand. This
fan should only be used standing and up-
right.
10. The fan cord must not be placed un-
der carpets, or covered with throw rugs,
runners or similar. Arrange the cord away
from the traffic area, and where it will not
be tripped over.
11. Do not operate the fan with a damaged
cord or plug, or after the fan malfunctions,
or has been dropped, or damaged in any
manner.
12. If the supply cord is damaged, it must
be repaired by the certified NASA Elec-
tric after sales service centers in order to
avoid a hazard.
13. Use the fan in a well ventilated area.
While in use, ensure that the air takes or
exhaust openings are not blocked un-ex-
pectedly, and the fan distance from the
wall or corner must be no less than 20cm.
The fan should not be placed below or
besides any curtains or similar.
14. To avoid mechanical danger when in
use, do not insert, or allow fingers, or any
other objects into the grill. Do not block
the air-intakes or the exhaust openings in
any manner.
15. The fan must only be placed, and used
on a flat dry floor.
16. Avoid placing the fan next to the win-
dow. Rainfall can lead to the risk of elec-
tric shock.
17. Make sure to keep the fan far away
from humidity, chemical articles and oils.
18. If you notice unusual oscillating mo-
tion, stop using the fan immediately and
contact NASA Electric after-sales service
for
19. Before removing the guard, unplug the
power cord.
Table of Contents Pages
Safety warnings ..................................................................................................... 03
StructureandParts ................................................................................................. 04
Assembly Instructions ............................................................................................ 05
Using the device................................................................................................. 05
Setup the fan........................................................................................................ 06
Troubleshooting ................................................................................................. 06
Cleaning and maintenance ................................................................................. 06
NS-1114
Stand Fan
Thank you for choosing our product. This instructions manual has
been prepared for you to achieve complete satisfaction and maximum
performance from your product read these instructions carefully before
using the appliance and keep the manual for future reference.
NASA electric Stand Fan NS-1114 User manual
Table of contents
Languages:
Other NASA electric Fan manuals
Popular Fan manuals by other brands
Kichler Lighting
Kichler Lighting Monarch II Patio instruction manual
RHOSS
RHOSS UTNC-EV Instructions for use
Progress Lighting
Progress Lighting AirPro P2582 installation manual
Ebmpapst
Ebmpapst A4E350-AA06-01 operating instructions
Zehnder Rittling
Zehnder Rittling Timer installation instructions
HOME DECÓ
HOME DECÓ 52560 manual