National ramp 2470-01 User manual

National Ramp New Elbow Quick Installation Guide (part number 2470-01)
Thank you for purchasing from National Ramp! This quick installation guide will focus on how to install the
new elbow. Check fit and trim handrails if necessary before installing the new elbow.
Tools Required:
 3/16 allen wrench/bit
 Pipe cutter/hacksaw/table saw (if cutting is required)
 Sanding/Filing tool (to remove burs and sharp edges after cutting)
Instructions:
1. Remove the two halves of the elbow
from packaging. One half will have the
nut and bolt to join the two halves.
2. Insert first half of the elbow into first
adjoining handrail.
3. Lock elbow into handrail by tightening
allen bolt (clockwise).
Tip: Do not fully tighten until fit/alignment has
been confirmed.
Do not use power tools to tighten. Do not over
tighten.

4. Repeat for other half of elbow to other
adjoining handrail.
5. Join two elbow halves using provided
bolt and nut and check alignment.
6. Once everything is aligned, fully tighten
all bolts locking elbow halves into
handrails (refer to steps 2 &3). Join
elbow halves and fully tighten bolt.
Do not use power tools to tighten. Do not over
tighten.
Installation complete!