Nauticam 36207 User manual

Current as of 2020-03-18
Instruction Manual for
Instruction Manual for Instruction Manual for
Instruction Manual for N85
N85N85
N85-
--
-N120 50mm
N120 50mm N120 50mm
N120 50mm
Port Adaptor II
Port Adaptor IIPort Adaptor II
Port Adaptor II
PN# 36207
F
FF
F
OREWOR
OREWOROREWOR
OREWOR
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM we pride ourselves in the ability to recognize the
requirements of professional as well as amateur underwater
photographers and fulfill them through the innovative designs of our
products. We strive to achieve a high level of user-friendliness by
allowing stress-free installation and easy operation of all important
functions of the camera.
Please read this manual carefully before using the product this will
maximize its performance as well as its lifetime.
W
WW
W
ARRANTY
ARRANTYARRANTY
ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for
consumer use. This warranty only applies to products purchased from
authorized NAUTICAM dealers and does not extend beyond the original
retail purchaser.
To return your product for service please contact your regional
authorized service center(s). Please note that this warranty only applies
when the product is purchased in the territory where the service center
is located.
NAUTICAM does not hold responsibility for damage of any nature to
any equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the
inability to capture images even if it is due to the malfunctioning of our
products.
Unauthorized modifications and/or repairs of our products will
automatically invalidate the warranty.
P
RECAUTIONS
After installation of the port combo please make sure the O-ring (s)
are free from debris and uneven surface issues.
A water-tight test without the camera inside the housing is highly
recommended after the changing of port and O-ring(s).
Do not use lubricants from other brands with the silicone rubber O-
ring on this housing only use the lubricant provided by NAUTICAM.
Discontinue use immediately should you notice any leakage.
Do not open the product in a wet or sandy environment. Protect the
interior from moisture and debris in order to prevent malfunction or
leakage.
Defective products should be shipped to our distributors for service
unauthorized disassembling and/or modifications could result in
malfunction or leakage.
P
ACKAGE CONTENTS
•N85-N120 50mm Port adaptor II
•Rear cap
•1x Spare O-ring
•Lubricant
•Manual instruction card
I
DENTIFICATION OF
P
ARTS
M
OUNT
THE
ADAPTOR
TO
A
H
OUSING
1. Install the camera body into the housing first and mount
the optical fiber cables to the housing in the case of using
strobes.
Please refer to the housing manual for installing camera
and mounting port to the housing.
2. Turn the port locking lever of the housing to the release
position as shown.
Port Release
Safety Button
Port Lock
Lever
Port
Alignment
‘I’ Mark
Port
Alignment
Index
Port
Cap

Current as of 2020-03-18
3. Align the port mounting indicates of the N85 to N120
50mm port adaptor II and the housing.
..
.
Then gently push the adaptor into the port opening of the
housing until it cannot go in any further.
M
OUNT THE
L
ENS
1. Lock the adaptor into place by turning the port locking lever
of the housing to the inward position. To ensure that the
adaptor is securely mounted confirm that the green line on
the safety button of the port locking lever is visible.
2. Mount the lens (with gears attached) on the camera.
Make sure that the zoom/focus knob on the adaptor is at
its most outward position before mounting/ dismounting
the lens. The knob should be left at this.
INSTALL
DOME
PORT
1. Lift the port lock/ release latch on the other side of the
adaptor. Then Press and hold the RED port release safety
button turn the port lock/release latch clockwise until it
stops.
2. Align the "I" mark on the adaptor with the WHITE dot on the
port. Gently push the port towards the adaptor until it
cannot go in any further.
3. Turn the port count clockwise until the white dot on the
adaptor aligns with the white dot on the port.

Current as of 2020-03-18
4. To lock the port in place turn the port lock/release latch
count clockwise to the original position and then flip it
down.
5. Engage the focus gear on the lens by pushing the knob
inwards then turn the knob both ways to check if the lens
is functioning
To unlock reverse the above procedures.
*36207 N85-N120 50mm Port Adaptor II is compatible with 36206 N85 -
N120 50mm Port Adaptor (With Zoom Control for N120 DSLR Zoom
Gears for Tokina 10-17) and NA-A6600 housing is only compatible with
36207
S
PECIFICATIONS
Port Mount : N85
Dimensions : DIA144.9×59.4
Type : N85-N120 50mm Port Adaptor II
Compatible
housings :
Sony N85 E mount housings such as
NA-A6300/A6400/A6500/A6600
Remark: Nauticam supports only e-manuals. Please download
corresponding product manuals on Nauticam.com website or contact
us for e-manuals