Nauticam NZ2875-Z Zoom Gear User manual

INSTRUCTION MANUAL
For NZ2875-Z Zoom Gear for
Nikkor Z 28-75mm f/2.8
PN# 19162
Thank you for your purchase of a NAUTICAM
product.
At NAUTICAM, we pride ourselves in the ability to
recognize the requirements of professional as well
as amateur underwater photographers and fulfill
them through the innovative designs of our
products. We strive to achieve a high level of user-
friendliness by allowing stress-free installation and
easy operation of all important functions of the
camera.
Each product is individually inspected and water
pressure tested to ensure optimum quality.
Please read this manual carefully before using the
product, this will maximize its performance as well
as its lifetime.
FORWORD
Current as of 09/26/2022

All NAUTICAM Products are warranted against
any material and manufacturing defects for two
years from the date of purchase for consumer
use. This warranty only applies to products
purchased from authorized NAUTICAM dealers
and does not extend beyond the original retail
purchaser.
To return your product for service, please contact
your regional authorized service center(s). Please
note that this warranty only applies when the
product is purchased in the territory where the
service center is located.
NAUTICAM does not hold responsibility for
damage, of any nature, to any equipment used
with and/or placed within our products.
NAUTICAM accepts no liability for any loss of
captured images or the inability to capture
images even if it is due to the malfunctioning of
our products.
Unauthorized modifications and/or repairs of our
products will automatically invalidate the
warranty.
WARRANTY

IDENTIFICATION OF PARTS
Spare Rubber grips
Plastic C-ring
NZ2875-Z Zoom Gear

MOUNT THE GEAR ON A LENS
1. Insert the plastic C-ring as shown and
place it over the lens.
2 Insert the NZ2875-Z Zoom Gear on the
plastic C-ring until it reaches the flange
of the plastic C-ring.
3. To remove the NZ2875-Z Zoom Gear,
reverse the above steps.
The tightness between the NZ2875-Z
Zoom Gear and the lens can be
adjusted by removing or adding rubber
grips on either sides of the plastic C-
ring, spare rubber grips are included in
the package.

CONTROL THE GEAR
1. The NZ2875-Z Zoom Gear can be controlled by zoom/focus knob of the
housing.
After mount the camera and lens (with gear installed) on the housing,
confirm that the zoom/focus knob operates correctly.