Nedlands Group EMS-PRO User manual

In Australia and New Zealand, only licensed electricians are permitted by law to work with electrical installations.
The Installer is responsible for ensuring compliance with all relevant building and safety codes and regulations i.e. AS3000 and AS2293.1.
DO NOT INSTALL OR CONNECT THIS PRODUCT UNLESS YOU ARE A LICENSED ELECTRICIAN.
ISOLATE THE ELECTRICAL SUPPLY BEFORE INSTALLING, DECOMMISSIONING OR REPLACING THIS FITTING.
DO NOT TOUCH THE TERMINALS WHEN THE LIGHT FITTING IS ENERGISED.
PLEASE DO NOT TAMPER OR MODIFY THIS FITTING. DOING SO WILL VOID WARRANTY.
INSTALLATION AND OPERATION MANUAL
SAFETY PRECAUTIONS
INSTALLATION
FIGURE 1
1. Unpack the fitting and inspect for any visible
damage. If damage is found, repack the
goods and return it to your point of sale for
replacement.
2. Mark the position of the fitting at the desired
ceiling location and provide a 75mm-150mm
diameter cutout.
3. Pass the inverter and battery pack through the
cutout and secure it against a solid structure e.g. beam or truss using screws.
4. Connect the inverter pack to the LED disc.
5. Guide the supplied flex cable through the cutout and conect the plug to mains power.
6. Then, pull back the two spring clips and release once it gets through. Ensure that the fitting is secure and
flush against the ceiling.
7. Once mains supply is present, only the green charge indicator LED will energise and remain lit. Allow a few
minutes for the battery to receive a small charge, then press and hold the test switch for a few seconds and
observe the LED lamp illuminating on emergency mode.
8. Under normal operating conditions, the emergency function will trigger automatically upon loss of supply to
the normal lighting circuit.
APPLICATION
This LED Emergency luminaire is intended for connection to an unswitched
active supply. When mains power is available, the LED lamp does not
illuminate but the green charge indicator LED comes ON. Mains power
provides continuous charge to the rechargeable batteries. When mains is
disrupted, the LED lamp receives supply from the internal batteries and
illuminates automatically.
Model
Input Voltage
Light Source
Battery
Autonomy
Mounting
Temperature
IP Rating
Mode
Material
Classification
Warranty
TECHNICAL SPECIFICATIONS
FIGURE 2
EMS-PRO
230VAC 50/60Hz
Twin High Performance LEDs
SYNTHIUM™ LiFePO4
> 120 minutes
Recessed - Cutout: 75mm - 150mm
0°C - 40°C
IP20
Non-Maintained
Flame Retardant Polycarbonate
C0 D80 C90 D80
3 years
Ø160 Ø100
Ø60
35
Recessed Disc
Controller
CONTROLLER
Ø75 - 150mm cutout
220 - 240VAC
53
155
30

5