Neptune NECPLBGN User manual

NECPLBGN/NECPLBWH
Installation Manual
6.Built-in buzzer status can be set as silent, intermittent or continuous.
The volume is adjustable.
4.Reset key with non-slip design
3.The outside plate will show the status (Green or Red)
2.Press the outside plate to enable the output function
1.Resettable design, LED indicators around the edge of the unit
7.Easy to assemble, outer case has no screws, 3 sets of output points to
connect other equipment, flush or surface mount installations.
Set as silent, intermittent, or continuous
Please depress the outside plate to make sure
the indicator flag turns red before opening the
front and middle covers to prevent the spring
from popping out.
Fixing Holes for flush mount
installation are set at 60mm
Terminal opening is restricted
as shown below

Surface Mount Installation
Flush Mount Installation
Use the key supplied to dissassemble B
and C fixings
Fix the unit as shown in the diagram above
Fix bottom cover C and connect the wires
Insert the key into the key hole. Pull the key out
when the flag turns green to complete the setting
Use the key supplied to
dissassemble B and C
fixings
No bottom C cover is
required for flush mounting
Use the key supplied to
dissassemble A and B
fixings
Remove the fixing
tabs not required for
flush mounting
Fixing tabs
Fixing tabs
Fix the middle cover B
and connect the wires.
Fix the unit as shown
in the diagram above
Insert the key into the key hole.
Pull the key out when the flag
turns green to complete the
setting
Status display