NetComm NF5 User manual

NF5
N300 WIFI GIGABIT
ROUTER WITH VOICE
NF5 - QUICK START GUIDE

THANKS FOR PURCHASING NETCOMM WIRELESS
FROM BOOM BROADBAND
This quick start guide is designed to get you up and running quickly with your new router. More
advanced set up instructions can be found in the user manual which can be downloaded from
www.netcommwireless.com
SET UP YOUR ROUTER
1. Take the supplied power adapter and attach it to the Power socket on the rear of the
router and connect the other end of it to a wall plug power source.
WPS/
RESET
ON/OFF
2. For use with a xed line connection, attach the Ethernet cable provided to the blue WAN
port on the back of the router.Attach the other end to your NBN CONNECTION BOX.
Usually you will need to connect to the UniD1 port.
WPS/
RESET
ON/OFF
CONNECTING VIA AN ETHERNET CABLE
1. Connect the Ethernet cable provided to one of the yellow LAN ports on the back of the
NF5 router.
WPS/
RESET
ON/OFF
2. Connect the other end of the yellow Ethernet cable to your computer.
NOTE: There is only one Ethernet cable supplied. If you require more than one Ethernet cable, any standard Ethernet cable is suitable.

N300 WIFI GIGABIT ROUTER
WITH VOICE - NF5
CONNECTING THE ROUTER TO THE INTERNET
1. After your router is powered up and
connected via ethernet, open a Web
browser and type http://192.168.20.1 into
the address bar and press Enter.
2. Enter admin into both the username and
password elds and click Login.The First
time setup wizard is displayed.
3. Click Yes, Let’s get started with the
wizard to congure your router.
4. Select WAN for the Interface setting.
5. Select the Ethernet WAN type PPPoE
(PPP over Ethernet) and enter the details
supplied in your activation e-mail.
These usually look like this:
Username
[e-mail]
Password
a1b2c3d4e5 (This is the default password)
6. After entering your details, click Next.
7. Choose to enable or disable your wireless
network, show / hide your wireless network
name (SSID Broadcast) or change the
wireless network name.After making any
desired changes, click Next.
8. Select the wireless security type and key
you would like to use and click Next.To use
the default settings, just click Next.

QSG-00035-BOOMrev1
9. If you would like change the default
username and password to log into the
web based user interface. Conrm the new
password by entering it a second time in
the Retype Password eld and click Next.
To use the default settings, just click Next.
Note: We highly recommend that you change the username and password
used to gain access to the Router Management Console for
added security.
10. Review your settings and if they are correct
click Finish. If you would like to make any
changes, click Back to reach the required
page and adjust accordingly.
11. The NetComm Wireless Router will
attempt to connect using the details you
have entered.This can take up to 2 minutes.
When a connection is successfully made,
the Internet Connection LED on the front
of the unit will be lit.
CONNECTING VIA WIFI
1. Ensure WiFi is enabled on your device (e.g. computer/smartphone/gaming console).
2. Scan for wireless networks in your area and connect to the network name that matches the
Wireless network name found on the Wireless Security Card (included in the box).
3. When prompted for your wireless security settings, enter the Wireless security key listed
on your Wireless Security Card.