Netelip Linksys SPA 303 User manual

1
Conguration guide for Linksys
SPA 303 IP telephone.
This manual explain how to congure a Linksys SPA 303 IP telephone for 3 lines
with Netelip service.
Step 1
First, obtain your telephone IP address. To get it, just press the “Set up” key as we
show in the next photo.
Then select “Network” and “Current IP” that will show your telephone IP
required to access to conguration.
Step 2
Enter the IP address obtained in the address bar of your computer browser.
Step 3
Click the button “admin login” in the upper right to access the conguration.

2 3
Then click the telephone extension you wish to congure. Linksys SPA 303 has up
to 3 lines.
Step 4
You must modify some parameters set by default.
Select YES to “NAT mapping enable” and “NAT Keep Alive Enable”
Proxy: sip.netelip.com or vpbx.netelip.com (in case you are conguring an
extension of your vPBX)
User ID and Auth ID: Enter your SIP user
Password: Enter your SIP password (These data were sent to you by e-mail when
you rst registered at www.netelip.com
Step 6
You can also name the extension to be showed in your telephone screen. Access
to “Phone” section and you will see next to each extension a short name to
dene.
Check this example, where we name line 1 as Ext. 100 so that calls coming
from this line will be dierence amongst calls coming from other lines on your
telephone.
Step 7
You can now start receiving and making telephone calls from Linksys SPA 303
with Netelip service using the best rates.
Enjoy the service.
To accept modications clic on “Submit all changes” at the bottom of
conguration page.
Step 5
Should you need to congure line 2, click “Ext.2” and repeat the conguration
steps mentioned. Please be sure to increase the SIP port on one more, for
conguration of each line of your terminal. For example, Ext1 SIP port 5060, Ext2
SIP port 5061.