NETGEAR ProSafe UTM9S User manual

Installation Guide
Install Module
To install the module:
Note: Only one DSL module can be installed. It can be installed in either
accessory slot.
1. Turn off power to the UTM9S unit.
2. Remove one of the blank plates on the UTM9s front panel.
3. Save the cover plate for possible later use.
4. Insert the module firmly into the UTM9S.
5. Secure the module using the two panel screws.
6. Restore power to the UTM9S.
Remove Module
To remove the module:
1. Turn off power to the UTM9S unit.
2. Remove two screws securing the module.
3. Pull the module straight back from the UTM9S.
4. If the module is replaced, follow the Install Module Procedure. If the module is
not replaced at this time, install a cover plate over the module slot.
5. Restore power to the UTM9S.
ProSecure™ Unified Threat Management UTM9SDSL Module
This guide describes how to install and remove the ProSecure Unified Threat
Management UTM9SDSL Module. Refer to the UTM9S Reference Manual for
configuration instructions. You can access the Reference Manual from the UTM9S
product management interface, via the Resource CD, or from the NETGEAR
support site: http://support.netgear.com.
Verify the Package Contents
• ProSecure™ UTM9SDSL Module
• Installation Guide
UTM9SDSL
UTM9SDSL_IG_28June11.fm Page 1 Friday, July 1, 2011 8:50 AM

June 2011
This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste
Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union,
this product should be treated and recycled in accordance with the laws of your jurisdiction
implementing the WEEE Directive.
©2011 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are registered trademarks of
NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are trademarks or
registered trademarks of their respective holders. Information is subject to change without notice.
Technical Support
After installing your device, locate the serial number on the label of your product and
use it to register your product at http://www.NETGEAR.com/register. Registration is
required before you can use the telephone support service. Registration via our web
site is strongly recommended.
Go to http://support.netgear.com for product updates and Web support.
For additional information about setting up, configuring, and using your Product
Name Only, see the User Manual.
For complete DoC please visit the NETGEAR EU Declarations of Conformity web
site at: http://support.netgear.com/app/answers/detail/a_id/11621/
UTM9SDSL_IG_28June11.fm Page 2 Friday, July 1, 2011 8:50 AM