nevins Arlo Table User manual

Assembly Instructions

Arlo Table | Assembly Instructions
(2) SHORT STRETCHER
LONG STRETCHERS
TABLE TOP
(4) CORNER LEGS WITH
ADJUSTABLE GLIDES
CENTER LEG WITH
ADJUSTABLE GLIDES
CORNER DETAIL
1
1
2
2
3
3
4
4
5
5

Arlo Table | Assembly Instructions
1
Working from the bottom (up-side-down), and from the
center out, attach all stretchers to legs using draw type
fasteners. Place fastener in pre-drilled holes and tighten
using Allen key. Refer to illustration.
Note: Not all tables have center legs
2
3
Flip base system right side up, and align table top holes to
the pre-drilled holes in the base. Using Connector Thru-bolts
and Allen key, hand tighten bolts. DO NOT OVER TIGHTEN.
Position fully assembled table in the final location and Level
using adjustable glides
Please read this sheet prior to assembly to familiarize yourself with the
installation process.
List of materials:
• Corner Legs with adjustable glides
• Center Leg(s) (# varies based on table length)
• Table Top
• Draw Type Fasteners
• Connector Thru-Bolts
Tools required:
• 4mm & 5mm Allen Key
• Level

Arlo Table | Assembly Instructions
1
Fit Upper legs with lower legs by aligning upper leg notch,
with lower leg notch. Secure with hardware provided
2
Align top threaded inserts located on the underside of the
table top with the pre-drilled holes in the base. Secure with
screws provided.
TABLE TOP
UPPER LEG
LOWER LEGS
2
Assembly Complete.