New Bright 81031 User manual

Component Checklist
(1 ) Vehicle (1 ) Transmitter
(4 ) Body Pins (1 ) Battery Charger (1 ) 9.6VBattery Pack (3 ) “AAA” Batteries
AAA AAA AAA
CAUTION!
CONTENTS
Do not recharge Battery Pack if it is hot or warm to the touch. Allow Battery
Pack to cool before recharging. Recharging a hot or warm Battery Pack will
shorten the life of the Pack.
Do not recharge a Battery Pack if it appears to be damaged or leaking.
Always unplug Charger when not in use.
Always remove Battery Pack from Battery Compartment when not in use.
Do not dispose batteries in re. Leakage, explosion and personal injury may occur.
Dispose of Lithium Ion Battery Pack properly.
Do not attempt to disassemble Battery Pack or Charger.
Do not use Battery Charger for any use other than instructed in this booklet.
Only an adult should charge Batteries.
Do not attempt jumps or tricks with this vehicle.

Battery Installation Features
VEHICLE
Locate and align arrow on battery
pack with arrow inside battery
compartment. Place battery pack in
battery compartment and slide
battery forward in direction of
arrow. Once in place, turn locking
tab to keep battery pack secure.*
*If battery pack is not
completely in place locking
tab will not fully turn.
(Steering Trim)
Wheel Alignment
ON/OFF
Switch
* If vehicle pulls to the left
or right during forward
driving the Steering Trim
may need to be adjusted.
The Steering Trim is located
on bottom of chassis
between the front wheels.

TRANSMITTER
Syncing
Battery Installation
Functions
1. Remove screw and slide to open battery
compartment cover on transmitter.
2. Insert 3 “AAA” size batteries.
Make sure the positive (+) and negative (–)
markings on the batteries match up to the
ones inside the Battery Compartment.
3. Replace the Battery Compartment Cover
making certain that the Compartment tab
has “snapped” into the locked position.
Replace the screw.
Note: When replacing Transmitter batteries:
Do not mix old and new batteries.
Do not mix alkaline, standard or rechargeable batteries.
Use alkaline batteries only.
Battery
Compartment
Forward/Reverse
Left/Right Steering
ON/OFF Switch
This transmitter is equipped with
2.4GHz technology which allows
up to 12 vehicles to be raced at
the same time.
When both the vehicle and
transmitter have the
batteries correctly installed
and turned on, the
transmitter will automatically
sync with the vehicle
R/C Dashboard
SPEED POWER

Charging
BATTERY
IMPORTANT!
The included 9.6V Lithium Ion battery pack is only PARTIALLY CHARGED prior
to shipment and it is recommended the battery be fully charged before rst use.
Push and Hold Button
To Remove Battery
9.6V Battery Pack
Battery Charger
Release Button
Charging Status
Light
1.Insert the 9.6V Lithium Ion rechargeable battery pack securely into the charger and push up
to lock. Be sure the arrows are properly matched (as shown above).
2.Plug the Charger into a standard indoor electrical outlet. This power unit is intended to be
correctly orientated in a vertical or wall mount position.
3.Allow battery to charge for 1-1.5 Hours. Charging Status Light will be solid red while
battery is charging. When charging is complete, light will blink green.
4.To remove the battery, press and hold the release button and slide battery down to unlock.
5.Charge will last approximately 12 minutes depending on terrain and driving style.
IMPORTANT: It is normal for the battery pack to become warm after charging and/or use. Be
sure to allow the battery pack to cool before using or recharging. Recharging a warm battery
pack will greatly reduce the battery life.
ATTENTION PARENTS:
• The Battery Charger & Battery Pack need to be periodically examined for potential
hazards. Any potentially hazardous parts need to be repaired or replaced.