Newport Brass 2920 User manual

I STALLATIO I STRUCTIO S
WIDESPREAD LAVATORY SET
Model o’s: 2920, 2950
Congratulations on the purchase
of this Newport Brass product,
an excellent choice, that will give you
years of quality service and enhance
the look and style of your home.
2920 2950

NWP-2920 Re A
Recommended Installation by a Professional Plumbing Contractor
ote: The use of petroleum base plumbers putty on our products will nullify the warranty. We recommend
the use of clear silicone sealing materials. Recommended deck thru hole Ø 1.38"
1. Place the spout’s threaded ROD (1) and HOSES (2) through center hole of mounting surface. Secure
spout into place with rubber GASKET (3), mounting CRESCE T (4) and UT (5). See Figure 1.
2. Place UT (7) and WASHER (8) on valve BODY (6). Insert BODY (6), (blue cold & red hot), through
hole in the mounting surface. Adjust and secure with additional WASHER (8) and UT (7) so that the
top of valve is 2” above the top of mounting surface. See Figure 1.
3. Connect HOSES (2) to side outlet of each valve BODY (6). Hand-tighten and secure each connection
with a wrench ¼ turn. See Figure 2.
5. Connect hot/cold water supply to appropriate 1/2” PSM valve BODY (6), utilizing one of the three fol-
lowing types of risers. Supply risers not included. See Figure 2.
a. 1/2” IPS flexible riser: discard rubber nosecone WASHER (9), friction WASHER (10) and coupling UT
(11).
b. 3/8” or 1/2” OD bullnose riser: utilize friction WASHER (10) and coupling UT (11).
c. 1/2” copper riser: utilize rubber nosecone WASHER (9), friction WASHER (10) and coupling UT (11).
5. Insert O-RI G (16) to underside of ESCUTCHEO (12). Place ESCUTCHEO (12) and BO ET (13)
onto cartridge. Place HA DLE (14) over cartridge stem. Any adjustments for rotational alignment must
be made to the valve BODY (6) – not to the cartridge. ( ote: Allow minimum spacing between HA DLE
(14) and BO ET (13) to prevent damage to the surface finish.) Secure HA DLE (14) into place with
SCREW (15). Then insert CAP (17) onto HA DLE (14). See Figure 3.
6. Remove AERATOR (18) from spout, turn on water supply and flush both valves until water is clear.
Check for leaks and make any final adjustments required. Re-attach AERATOR (18) to the spout.
See Figure 3.

Figure 3
14
13
12
15
16
6
Figure 1
5
43
2 1/16”
1
7
8
7
6
2
b
11
10
9
10
11
c
Figure 2
a
2
6
1/2”
PSM
[phone]
NWP-2920 Re A Santa Ana, Ca. 92705 01/27/17
www.brasstech.com
18
17