Newskill HORUS Manual

HORUS
INSTRUCTION GUIDE



























Type C Chair
C-Stuhl
Silla tipo C
Sedia tipo C
Chaise de type C

COMPONENTS
1
5
9
17
18
12
10 13
11 14
6 7
15 16
8
2
3
4
Backrest Seat
Head Support
Cushion
Mechanism Side Cover Gas Li
Base
Arm Rest Hex Key
Gas Li Cover
Lumbar Support Cushion
Castors X5 M5x12mm Screws X2
M8x20mm Screws X8 Anti-slip screw X4
M8x25mm Screws X4 Gasketx4 RubberGasketx4

MOUNTING STEPS
8
11
11
11
16
16
2
17
7
9
10
1
2
11
Push and twist the wheels into the star base.
And place the cylinder cover over the gas li.
Align the buerfly mechanism with the screw
holes at the bootom of the seat as shown in
image above.
M8x20mm Screws X8
Rubber gaskets can reduce the noise when
the chair is in motion. You can choose
whether to install it.
The Rubber Gasket

3
4Fasten the backrest
with provided screws.
Aache the seats
to the base.
12
14
15
12
M8x25mm Screws X4

5
6
Fasten the side covers, and put
the small side cover on
Finish
13
6
13
M5x12mm Screws X2

1. Verify all parts before assembly.
2. The pictures in this guide may not look like your chair, but the instruction guide is the
same regardless of model.
3. Do not use the chair unless all the bolts and screws are tight.
4. At least every six months check all botls and scres to ensure they are tight.
5. Don not use this chair as a step stool/ladder.
ATTENTION!
GOT QUESTIONS? newskillgaming.com
Go newskillgaming.com