Newskill KITSUNE RGBV2 Manual

KITSUNE RGBV2
I N S T R U C T ION G U I D E

COMPONENTS
MOUNTING STEPS
1. Seat
2. Backrest
3. Lumbar Support Cushion
4. Head Support Cushion
5. Mechanism
7. Castors
10. Right Side Cover
11. Base
12. Hex Key
13. 8*20mm M8 Screws
14. 2*12mm M6 Scres
15. Small Side Cover
1
9 10 11 12 13
13
13 16
12
14
14
15
15
16 17
2 3 4 5 6 7 8
16. Screw Washers
17. Rubber Gasket
Mount the lumbar and head support cushions on the backrest
Fasten the backrest with provided screws.
20mm M8 Screws
Fasten the side covers, and put the small side cover on
1
3 4
2
9 10
12mm M6 Screws

5
6 7
Place the rubber gasket on the screw hole
There are two
connectors, one is
on the backrest,
another is on the
seat. Please connect
them together.
Find another USB connector in
the back of chair. Connect it on
the power with low voltage such
as the power bank. The light will
work when power is connected.
Align the mechanism
with screw holes
Tighten the screws
Rubber gaskets can reduce the noise when the chair is in motion. You can choose whether to install it.
The Rubber Gasket
Power Connections
Rubber gasket
20mm M8 Screws
Push and twist the wheels into the star base. Place the chair face down and insert the star
ATTENTIONThe voltage couldn’t over 6V.
1 2

1. Verify all parts before assembly.
2. The pictures in this guide may not look like your chair, but the instruction guide is the
same regardless of model.
3. Do not use the chair unless all the bolts and screws are tight.
4. At least every six months check all botls and scres to ensure they are tight.
5. Don not use this chair as a step stool/ladder.
ATTENTION!
GOT QUESTIONS? newskillgaming.com
Go newskillgaming.com