Newskill KAIDAN Manual

KAIDAN
INSTRUCTION GUIDE



























Type C Chair
C-Stuhl
Silla tipo C
Sedia tipo C
Chaise de type C

COMPONENTS
1
5
11
12
14
13
15
6 7
16
17
8 9 10
23
4
Seat Backrest
Head Support
Cushion
Mechanism Castors X5Gas Li
Base
Gas Li Cover Side Covers
Lumbar Support Cushion
Hexkey
M5x12mm Screws X2
M8x20mm Screws X8
Small Side Cover X2
M8x25mm Screws X4
Screw Washers X4
RubberGasketx4

MOUNTING STEPS
8
6
13
13
17
17
11
7
1
2
11 17
Push and twist the wheels into the star base.
And place the cylinder cover over the gas li.
Align the buerfly mechanism with the screw holes
at the bootom of the seat as shown in image
M8x20mm Screws RubberGasketx4
Rubber gaskets can reduce the noise when
the chair is in motion. You can choose
whether to install it.
The Rubber Gasket

3
4Fasten the backrest
with provided screws.
Aache the seats
to the base.
1613
13 16
M8x25mm Screws X4 RubberGasketx4

5
6
Fasten the side covers, and put
the small side cover on
Finish
14
9 10
14
M5x12mm Screws X2

1. Verify all parts before assembly.
2. The pictures in this guide may not look like your chair, but the instruction guide is the
same regardless of model.
3. Do not use the chair unless all the bolts and screws are tight.
4. At least every six months check all botls and scres to ensure they are tight.
5. Don not use this chair as a step stool/ladder.
ATTENTION!
GOT QUESTIONS? newskillgaming.com
Go newskillgaming.com