L.L.Bean MISSION COFFEE TABLE User manual

MISSION COFFEE TABLE
Thank you for purchasing our Mission Coffee Table. Assembly
of this product requires a Phillips screwdriver and a hammer.
We have found it helpful to have a second person present in at
least one step of the assembly.
7612 0LVS9120410

STEP 1
Read through these instructions
thoroughly before beginning
assembly. We have found this to
be of great value when first
assembling this product.
STEP 2
Remove all parts and hardware
from packing material. Wooden
pieces should be placed on a non-
abrasive surface (like the carton or
carpet) to prevent damage to the
finish. Identify all parts using
diagram at right.
STEP 3
Identify and count hardware using diagram
at right.
Assembly of this product requires a Phillips
screwdriver and a hammer. We have found
it helpful to have a second person present in
at least one step of the assembly.
STEP 4
Lay one side assembly (A) on edge
and attach to bottom shelf (B) using
two 1 ¼” screws. Thread screws
into counter-sunk holes in
crosspiece into the predrilled holes
in the bottom shelf. Do not tighten
screws. Attach both stretchers (C)
using two 1 3/4” screws. Thread
screws into counter-sunk holes in
leg into the predrilled holes in
stretcher. Do not tighten screws.
Repeat for other side.

STEP 5
Attach drawer (D) hardware as
shown at right. Repeat to other side
of drawer, so all 4 pulls are attached.
STEP 6
Place Drawer (D) onto the frame
assembly resting on the stretchers.
Lift one side of drawer up and place
shuttle block into groove on drawer
side. Make sure the 1” width of
block is in the groove. Carefully set
drawer back onto the frame so
shuttle block is resting on the cleat
attached inside the side assembly
(A). Repeat to other side of drawer.
Note: the shuttle blocks will act as a
drawer stop when pulling the drawer
out from either side.
STEP 7
Lay top (E) upside down on a
protective area and using (2) 3/8”
screws attach each bracket to the top
aligning the bracket over the
predrilled holes. Note: make sure
the single hole tab of bracket is
placed to the outside edge on each
side. Repeat for each of the four
brackets.

STEP 8
Place top (E) onto the unit
carefully, making sure the tabs of
the brackets fit between the drawer
and sides. Push the drawer into the
frame like the photo at the right
shows. Align the bracket over the
predrilled hole on the side assembly.
Use a 3/8” screw and securely fasten
the bracket to the side assembly.
Repeat to the right side and then
push the drawer through the other
side and repeat to the other 2
brackets.
STEP 9
Now tighten the four screws on each
side and tap in wood plugs gently
with hammer to conceal screw
holes.
CARE
Dust as needed with a soft cloth. Clean with
damp cloth and mild solution of dish soap.
Polish with soft cloth and polish that contains
no pigments or silicone.
www.llbean.com
Product Support 1 800 341 4341